See part 12 in the diagram
( Grid squares measure 1x1 inch )
Defrost Heater and Thermostat Assembly
$
54.36
In Stock
In Stock
Get this part fast. Average delivery time via standard shipping: 1.8 days.
PartSelect Number PS11743275
Manufacturer Part Number WP61006116
Manufactured by
Whirlpool
Product Description
Defrost Heater and Thermostat Assembly Specifications
This part assembly has 2 functions: The defrost heater keeps the cooling coils from freezing and the thermostat can tell that the heat next to the cooling coils has reached the desired temperature.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Fridge too warm | Freezer not defrosting | Freezer section too warm
This part works with the following products:
Refrigerator.
This part works with the following products:
Maytag, Crosley, Admiral, Amana.
Part# WP61006116 replaces these:
AP6010099, 61003119, 61003120, 61004286, 61004307, 61004337, 61004476, 61006082, 61006116
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Douglas
May 29, 2019
Replacing the part wp61006116 will this stop the coil freezing and keep the refrigerator cold. At the moment I have to annually defrost the freezer part and coils to get the refrigerator to stay cold for only a week.
For model number MSB2354AR
Hello Douglas, Thank you for the question. I woudl suggest testing the part. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. Hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Customer Repair Stories
Average Repair Rating: 3.6 / 5.0, 3 reviews.
What's this?
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
defroster element and or thermostat was not working.
removed the shelves in the freezer compartment and removed the two screws holding the back panel on over the coils and simply removed the male wire plug from the female plug and pulled the wires for the heating element down thru the coils and released the spring clip holding the element in place and removed, and installed the new element and thermostat in reverse order. Very simple.
-
Thomas from Cottage Grove, MN -
Difficulty Level:Really Easy -
Total Repair Time:Less than 15 mins -
Tools:Nutdriver -
Parts Used:WP61006116
37 of 43 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Not defrosting the coils warming up the compartments
Removed housing on the freezer side and removed the assembly by removing the two bottom clips and then unclipping the wire harness, two prong, and replaced as remvoved. Power was off of course. Watched for 24 hours and recovered housing and its been working great.
-
Steve from Marion, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
-
Parts Used:WP61006116
18 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cannot contact via instruction given by Parts Select so they can answer question below.
Recently I ordered a defroster element from PartSelect Number PS11743275 Manufacturer Part Number WP61006116 for my Maytag Refrigerator/Freezer Model MSD2354ARW. The part received has two numbers on the bag containing the part #61006198 and WP61006198. It looks similar to the picture but the wire connection has three sockets while the element in my freezer has two. Could I have received an incorrect part?
Where do I go from here?
Thanks,
Shaun English
9318 Brambly Lane
Alexandria, VA 22309
703-229-3317
spenglish@aol.com
Where do I go from here?
Thanks,
Shaun English
9318 Brambly Lane
Alexandria, VA 22309
703-229-3317
spenglish@aol.com
-
Shaun from ALEXANDRIA, VA
-
Difficulty Level:Very Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:
-
Parts Used:WP61006116
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer Reviews
Filter By Rating:
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
JONATHON H - July 12, 2020
Easy repair
It work and I got it from parts select faster than I could get it from the local parts store. Saved me from having to buy a new refrigerator.
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11743275
Manufacturer Part Number: WP61006116
Manufacturer Part Number: WP61006116
Brand
Model Number
Description