Quick Question!

Have you ever purchased from PartSelect.com before?

See part 32 in the diagram

Defrost Heater

Your Price

Get this part fast. Average delivery time via standard shipping: 1.8 days.

PartSelect Number PS11743094
Manufacturer Part Number WP60106-35
Manufactured by Whirlpool

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

This part works with the following brands: Admiral, Maytag, Magic Chef, Crosley, Amana, Jenn-Air, Hoover, Norge, International.

This part works with the following products: Refrigerator.

This part fixes the following symptoms:

  • Fridge too warm.
  • Freezer section too warm.

Questions & Answers

Ask our experts a question on this part and we'll respond as soon as we can.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.8 / 5.0, 2 reviews What's this?
1-2 of 2

30 of 45 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 1- 2 hours
Tools: Screw drivers, Socket set, Wrench set
Customer: Robert from Salado, TX

Fridge. Freezing up

First I thank parts select for such fast shipment and correct parts.
The main problem was defrosting the coils between the freezer and fridge. The cover plate over the coils could not be removed untill some of the Ice melted.Removed freezer door, and screws each side of outer frige cover to enable cover plate to slide out.(Outer walls have to be pried out a little). R&R heater coil (shorted out and glass broken).Defrost thermo.located behind coils replaced as precaution. Defrost Timer located at bottom of fridge frame next to compressor. A couple of screws and unplug and plug in new part .(Also replaced as precaution-not qualified to test and dont want to do the job over) Thanks to google for info.First time for this job. You can do it.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

15 of 16 people found this instruction helpful

Parts Used:
  • Defrost Heater
Level of Difficulty: Very Difficult
Time to do repair: More than 2 hours
Tools: Pliers, Screw drivers, Socket set
Customer: chuck from dudley, NC

Freezer would not keep food frozen

First you must unplug the refrigerator, then remove the top hinge and freezer door, then you must remove the middle hinge to remove the refrigerator door, after that there are 4 screws located in the refrigerator compartment that must be removed that are holding the plastic control knob trim in place. When you remove these screws and drop the trim piece you can unplug the wiring on it, to completly remove it, next right above the plastic trim previously removed there is a metal trim with 3 screws holding it in place they will be removed now. Now you need to remove all of the shelving in the freezer compartment these pieces will just snap out , at the lower left and right sides of the freezer compartment there are two plastic tips that are attached to the main plastic body of this compartment they will need to be snapped out from behind the metal body of the refrigerator this can be done with a flat head screwdriver. Now pull straight out on the plastic body and it should come out , this will expose an insulating cover over the freezer coil where the defrost heater is located,if this is covered with ice you will need a heat gun which is a overgrown hair dryer basically. To melt the ice you will have to remove a insulating cover that is located behind the previously removed front metal trim it will come out by gently snapping it out of place, use caution during this step so not to break the cover in half. This will expose the front of the freezer coil and you can now use the heat gun to melt the ice, keep a check on the drain pan beneath the refrigerator as it will have to be emptied depending on the amount of ice build up. As the ice melts it should release the top cover of the coil and this will lift out of place also again use caution when removing the cover. With the coil exposed melt the remaining ice, if you look in the coil you will see the defrost heater, if the glass tube on the heater is broken please use extreme caution so you will not get cut by it , now you can unplug each wire from each side of the heater you may need a pair of pliers for this. when the wires are unplugged you can now lift out the bad heater again use caution if the glass is broken. There is a gaurd over the heater that will have to be removed by sliding it off the end wires when you have this off, slide it over the wires on the new element, now gently install the new heater back in the coil reconnect the 2 end wires and make sure they are connected good. you can now assemble all of the covers and parts in the reverse order you removed them, when assenbly is complete plug the refrigerator back in and in about three hours or so you should here the fan and compressor stop and the unit should go into a defrost cycle during this you should here the water running to the drain pan as it melts.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2

Model Cross Reference

This part works with the following models:

PartSelect Number: PS11743094
Manufacturer Part Number: WP60106-35
Brand Model Number Description
AdmiralAT19M8ARefrigerator - Top Freezer
AdmiralAT19M8VRefrigerator - Top Freezer
AdmiralAT19N8ERefrigerator - Top Freezer
AdmiralAT19N8MRefrigerator - Top Freezer
AdmiralAT21M8FARefrigerator - Top Freezer
AdmiralAT21M8FVRefrigerator - Top Freezer