Electronic Clock Control with Overlay - Black Specifications
This part comes with the P13 series connector.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Range.
This part works with the following products:
Jenn-Air.
Part# WP5760M302-60 replaces these:
5760M302-60, 74006131, 74008207, 74009314
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim Sitton
October 23, 2019
My jenn air model jds9860, continues to heat past bake set point the thermostat is working as it is reading temp as it heats to set point. The top element counties to stay on until overheat is reached. Would this be a faulty control board?
For model number 336-312-5289
Hello Jim, thank you for your question. This issue would be in relation to a bad sensor, or a bad electronic control board. To determine which is the problem test the sensor. It will need to be disconnected and tested with an ohm meter. At normal room temperature, the oven temperature sensor should have a resistance of 1050-1100 ohms. If it is not close to this it would need to be replaced. If the sensor is tested and reads within that range, the issue is the electronic control board and would have to be replaced. Good luck with your repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Jakki
January 23, 2020
Oven control panel shuts off and on intermittently and blinks when power returns. Is this faulty panel or power issue?
For model number JDS9860AAP
Hello Jakki, Thank you for the question. This sounds like a defective Electronic Control Board that may need to be replaced. We hope this helps.
Was this helpful?
Thank you for voting!
Tom
December 22, 2017
Oven will not reach temp over about 250, temp sensor oms ok, so does lower heating element but it does not get very hot. Repairman says heating element is not getting 240v only 120v needs to replace the control panel, is this likely? Broiler works ok and convection fan comes on.
For model number JDS9860AAP
Hello Tom, Thank you for your inquiry. I would also check the high limit thermostat first, part# WP71001844. If the continuity on that checks out ok, then test the electronic control board. Good Luck with your repair!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
