Average Repair Rating: 3.0 / 5.0, 2 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Washer would not spin
took off back and sides to the washer. laid the washer on it's back and removed worn and broken parts. replaced these parts and put everything back together. The top part of the agitator hasn't worked in a while, while we had it apart we also replaced the clogs. The washer works better than it has in a long time. Spins a lot more wat
... Read moreer from the clothes which makes drying faster. I would surely do this again. A lot cheaper than a new washer.
Tub did not center and seal was hanging out of tub
Laid washer on front side and removed top spring, then lifted the tub assembly to replace the right side spring, the one behind the motor was the hardest, I lifted the tub then removed the spring bracket at the tub with pliers and a socket. The top seal all I had to do was take the 4 screws that hold the top on (it takes a long extension)
... Read more then sit it bak up and I lifted the top up to give me enough room to unsnap the top piece of the tub, cleaned it up put seal in. The parts fit perfitlt and real fast shipping, I bookmarked the site and will buy from again. JIM
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Rick
August 27, 2017
The machine shakes excessively in spin cycle like it's out of balance, even when empty. I had laid it down to replace pump. Could that have done something?
For model number LSR6232JQ1
Hi Rick,
Thank you for your inquiry. You may have jostled one of your suspension springs out of place or, if you removed them to replace your pump, you may have put them back in the wrong place. I would suggest checking your springs to see if they are all alright. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Greg
August 20, 2019
The 20 year old top load machine shakes to the point of moving during the spin cycles. I plan to replace the suspension springs, etc. To try to remedy the shaking. The tub wear pads look like they are the hardest to replace. My question is this - are there any gaskets that normally will need to be replaced when i install the other parts? Thanks.
For model number 110.28922790
Hello Greg and thanks for writing.
You are on the right track . There shouldn t be any gaskets to be replaced .
Just the following if defective :
Suspension spring WP63907 Tub spring WPW10250667 Tub wear pads 285744 Hope this help. Please contact us anytime.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Barry
February 10, 2022
Part# WP3976308 Does this part replace gasket ring on a Kenmore washer Mod. 110. 42932 200 ? I think it's # 10 on the diagram.
For model number 110.42932200
Hello Barry, thank you for writing. No, the part you had chosen is not compatible for your model. Based on the model 110.42932200 the correct Tub Ring Gasket is Number PS11744912. We hope this helps.
