Water Pressure Hose - Cut-to-Fit

Hi John, Thank you for the question. Unfortunately we do not offer a video at this time on how to install the pressure switch and hose on your model number.Here are some basic steps.Remove the two Phillips-head screws in the front corners of the console on the top.Tip the console back on the hinges that secure the top of the console to the washer.Once you have the console loose, you need to remove the knob, and remove the air hose from the switch.Then remove the cabinet to access the air hose where it attaches to the outer tub assembly, on the right rear portion of the tub. Remove the console screws and tilt the console into the service position. Unplug the lid switch connector from the connector in the washer top. Remove the cabinet mounting clips by using the flat blade screwdriver in the clip. Remove the cabinet by tilting it forward and pulling it away from the washer. The rear panel can be tilted back for better access to components at rear of machine by twisting the rear panel support 90°. and then tilting the rear panel back.Hope this helps!

Hi Paul, Thank you for contacting us regarding this situation. If your washer is not letting in hot or cold water, then There are some parts that you will need to check to see which one is causing the issue. You will need to check the water inlet valve, the water lines and the lid latch assembly, I hope this helps. Thank you and have a great day!

Hello Dean, Thank you for the question. In order to troubleshoot the issue we will need a bit more information. What cycle is it in when it will not finish? Can you turn the knob manually and have the cycle finish? Are you getting any errors or blinking lights? The more information the better. Look forward to hearing from you.

Hello Dave, Thank you for the question. If hitting the appliance turns the pump off, you could have a loose wire connection somewhere. If the Wiring is good, this could indicate a defective Control Board or Drain Pump. We hope this helps!

Hi Ken, Thank you for your question. If there is water in your detergent dispenser after a cycle. Take the detergent drawer out and give it a good cleaning to remove any soap or fabric softener residue from it. This should should resolve the issue. I hope this helps. Thank you and have a great day!

Hello Vicki, Thank you for the question. This sounds like the water valve is becoming stuck open and is defective. The valve is not repairable so it will need to be replaced, PartSelect Number: PS11749042. Hope this helps, good luck with this repair!

Hi Yetzel, Thank you for your question. The F32 error code stands for Long Drain which means the control has recognized the water in the tub is not draining fast enough during the cycle. Here are some things that you will need to check. Make sure the pump and drain hose are clear of debris that would cause a blockage. Check the impeller on the drain pump and make sure it is not damaged. Remove the tub hose from the pump to the tub and check it for blockage. Make sure the pump is running and that it is getting the proper voltage when it should be. If everything checks out fine, then replace the drain pump motor. I hope this helps. Thank you and have a great day!

Hi Brenda, Thank you for your question. The LF error code is letting you know that the washer is taking too long to fill with water. If you have checked the hoses and they are clean and the water is turned on for the water inlet valve, check to see if the valve screens are clear. If they are try pressing POWER/CANCEL to clear the display to see if the LF error code will remain or if this clears it. I hope this helps. Thank you and have a great day!

Hello Karen, thank you for your question. We would recommend testing/replacing the Shift Actuator - 120V 60Hz Part Number: WPW10006355 first. If that isn't the problem, the cause of this issue might be with the electronic board. I hope this helps!

Hello Michael, thank you for your question. The Water Level Switch is part PS11751469. It senses and controls the water level in the washer. We hope this helps.