The thermal limiter is a safety device designed to prevent overheating in the dryer.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Washer Dryer Combo.
This part works with the following products:
Whirlpool, Kenmore, Maytag, Crosley.
Part# WP3403607 replaces these:
3391927, 3403607
Customer Repair Stories
Average Repair Rating: 3.8 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Connection to heating element were loose.
I squeeze the cable connection to heating element so the thermal fuse does not cut the electrical current. The loose connection cause the thermal fuse to blow.
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kenneth
January 14, 2018
My dryer will start up fine including gas ignition. It will operate normally for 5+ minutes and then the flame will go out but the dryer will continue to run. The timer will not advance except in timed heat mode. I have tested the cycling thermostat and it appears to operate within specifications (continuity up to 155 degrees then interruption above). There is not any continuity on the thermal limiting sensor. Should there be? Would this faulty thermal limiting sensor cause the previously described scenario?
For model number LTG6234DQ0
Hello Kenneth,
Thanks for your question. The thermal limiting sensor should show continuity, and as such, we would advise replacing it. You may also want to test the gas coils to see if they are functioning properly, as that can also cause this issue.
I hope this helps.
