| |
3 of 4 people found this instruction helpful
Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver
Customer: Frank from Hampton, NH
Worn down agitator directional cogs
Looking at the Whirlpool web page for this model number it was easy to order 1. agitator directional cogs; 2. Inner cap seal and 3. washer for agitator bolt; After you remove agitator cap barrier you see agitator bolt that you need to remove (it's a little tricky) and the rest you do by intuition. I am not an repairman but looking at the whirlpool web for this model it was incredibly easy. Before repair the agitator upper part was not moving at all. Professional repair estimation was $100.
|
0 of 1 people found this instruction helpful
Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers, Wrench (Adjustable)
Customer: Luis from Perth Amboy, NJ
Top part of washing driver was not spinning
Unbeleivably easy, thanks to the parts being available. Twenty bucks in parts and saved me on buying a new machine. Awesome website, great pics on parts!
|
0 of 1 people found this instruction helpful
Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Wrench (Adjustable)
Customer: Charlene from Jacksonville, FL
Upper part of agitator would not turn
I didn't fix it, my husband did. It had to be simple because it didn't take any time or much effort at all.
He wanted to call a repairman but I went on line, found Parts Select and ordered the kit.
|
0 of 2 people found this instruction helpful
Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Pliers, Screw drivers, Socket set
Customer: Mark from N. Port Florida, FL
Water coming into washer slowly. Agitator not pulling close down and would move both directions.
Unpluged washer and turn off water supply to washer.Used channel locks to take hoses off back of washer.Then unscrew to screws in top panel and then flip it back. Take screw driver and pop out the two clips and unplug lid switch. Now you can pull off front section of your washer. Use your socket to remove the two nuts on back panel and unpluged the hot and cold plugs.Use channel locks to pull back of hose clamp. You may need to put mounting plate on the back of the inlet valve. Put back in reverse order. Good Luck Mark N. of North Port FL
|
18 of 531 people found this instruction helpful
Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Socket set
Customer: Daniel from Naples, FL
Upper agitator not rotating.
Removed the degergent cone. Removed the cap with handle and o ring. Removed 1/2 bolt and washer with deepsocket and extention. Removed upper agitator and gear wheel and replaced pieces with new repair kit.
|