Pantry End Cap - Left Side WP12656105

The videos provided by PartSelect for both repairs were excellent. Repairs went exactly as per videos. Door gasket arrived with deformations do to folding in storage and shipping. Used hair dryer to remove puckers as instructed in Video. This is a must before installing gasket.

Easy

First, turn off the refrigerator so the open door alarm doesn't drive you crazy while you are working with the refrigerator doors open! Then, remove both crisper drawers, remove deli drawer, remove deli cover from two pins (one was already broken), remove the bottom glass shelf and the plastic glass support. None of this requires any tools, all just slide or lift out. Then, using a nut driver remove the two screws holding the drawer slide from the pantry end cap. You access one of the screws from an opening while the slide is all the way in. This is where I needed needle nose pliers to remove the screw from the opening after it was unscrewed - if your nut driver is magnetic you won't need the pliers. To access the second screw, pull the slide all of the way out. Then you remove the broken end cap by unscrewing 3 screws with the nut driver. Once the screws are removed, you lift up on the front of the end cap to loosen it from a catch on the inside and then pull the end cap out. Install the new end cap by sliding the two tabs into the back of the refrigerator and then pushing down on the end cap to set it in the catch. Now replace the screws, re-attach the slide with the two screws, reinstall the glass and the drawers and then reinstall the drawer cover by slipping it into the pins on each side (be careful when depressing the pins, do it gently or they may break off). Turn the refrigerator back on. You are done These instructions make it sound much more difficult than it actually is, it takes as long to remove and replace the drawers and it does to do the actual installation of the end cap..

1. Removed both crisper drawers. 2. Removed glass 3. Philips head screwdriver to remove the 2 screws securing guide rail. 4. 1/4" nut driver to remove the 3 screws holding the End Cap than removed and replaced with new one. Done.

First of all the part came in less than 24 hours, amazing. It was very simple to repair and everything is as good as new. Thanks so much for being such a great company to work with. I have ordered other replacement parts before from you and will continue to use your company.

I removed the drawer, the two drawers above it and the glass plate. I removed the left end cap, unscrewed the metal runner from it and put it onto the new end cap. I installed the new end cap into the refrigerator and replaced the various drawers and covers. The pop-up was a little tight, so I removed the drawers again and loosened the screws to center the drawer, replaced everything and voila! a perfectly working pop-up without having to wait for a repairman or pay the very high repair fees. The part was shipped and arrived within two days - Great service. Thanks

Replaced the left side endcap for the drawer. Three screws and it popped out. Easy process once I actually looked at it. Drawer cover now works as designed. Replaced inline water filter. Not problem there.

Repair was simple and just as described by several others on this site! From finding the part, ordering, quick shipping and instructions, PartsSelect made this job a breeze to complete.

The repair required that I removed two drawers and a glass panel; removal of three screws completed the disassembly process. The ordered part was delivered without delay, which made the repair almost a pleasure.

Required removal of the entire endcap piece. A total of 5 screws. Hardest part was realizing i didn't have the right size socket wrench to start. Got that and replaced all 5 screws in under 5 minutes. $18 for part, $10 for tool.