Ask our experts a question about this part and we'll get back to you as soon as possible!
6 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bruce
June 4, 2019
The dishwasher will not go through all of the cycles. It will fill with water and drain.
For model number WDF310PLAB5
Hi Bruce,
Thank you for your question. If the dishwasher is stopping in the middle of a cycle, the issue may be caused by either the door latch, the electronic control board or the heating element. Check to see if you have an adequate water supply. If you are not getting a good supply of water, this could cause the dishwasher not to work properly. Also, if you are overloading the dishwasher this may prevent it from cleaning properly and cause it to shut down. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Carolyn
October 20, 2021
The unit wouldn't start, nothing lit up. There is power to the dishwasher. I don't see a fuse. I can't match or search part numbers. How can I be certain that I order the correct parts? The control part # is Whirlpool W11100742 REV B.
For model number KDTM354DSS5
Hello Carolyn, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS12745077 for the Electronic Control Board. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Our dishwasher doesn't finish washing, some of the lights don't light on the control panel, it stop washing on light cycle, now it's stopping on normal. We have to hit cancel and drain for it to drain
For model number Wdf310paaw5
Hi Rob, thank you for reaching out. The issue is probably with the electronic control board and you may need to replace it with part number PS11722935. We hope this solves your problem! If you need help placing an order, customer service is open 7 days a week. Thanks again for your great question.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Melvin
September 6, 2021
Dishwasher goes through all the cycles but the heating element dose not work had the heating element and the thermostat checked out both are good
For model number WDF310PAAS1
Hello Melvin, thank you for your question. Check your dishwasher cycle settings. You may have to turn on heated dry. Quick-wash or express wash settings do not include the heated dry cycle to conserve time, meaning you are likelier to have wet dishes when using one of these speedier settings. Inspect the rinse aid dispenser. Energy efficient dishwashers depend on rinse aid for optimal performance. Pour in enough rinse aid until the indicator shows it is full. If there is already enough rinse aid in the dispenser, a buildup of gunk could be preventing the rinse aid from dispensing into the machine during the rinse cycle. To clean the rinse aid dispenser, remove the cap, then set a dishwasher-safe bowl filled with two cups of white vinegar on the top rack of your otherwise-empty dishwasher. Leave the rinse aid dispenser cap off, and run the appliance on the hottest water setting. If these solutions do not solve the problem, it could be the rubber washer, part number PS11743934. We hope this helps. Good luck with your repair.
would a bad circuit board be the cause of the heating element not to work?
For model number wdf310paas4
Hello Robert, thank you for contacting us. It is possible that a defective board would stop the heating element from heat production. A more probable cause is a blown thermostat, part number PS11743423. We would also recommend checking the heating element itself, part number PS8260087, with a multimeter for continuity. Customer service is available 7 days a week if you require assistance placing an order. Thanks again for reaching out!
7 year old portable.
Sometimes won't drain
Other times works correctly.
Control module?
Pump motor?
For model number WDP350PAAB5
Hello Ralph, thank you for getting in touch. Based on our research, we would recommend checking the drain hose for blockage. If this does not resolve the issue, then you may need to check the drain pump, part number PS11738151, to solve the problem. We hope this helps!
Item is in stock and will ship today if your order is placed before 4:00 PM Eastern Standard Time.
If your order is placed after 4:00 PM EST, the in stock items will ship on the next business day.
On Order
Item is not in stock and usually ships 3-5 business days from the time you place your order.
Special Order
Item is not in stock and usually ships 10-15 business days from the time you place your order.
NLA - No Longer Available
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Dishwasher","title":"Dishwasher","url":"/Dishwasher-Parts.htm"},{"position":2,"name":"Circuit Board or Touch Pad","title":"Circuit Board or Touch Pad","url":"/Dishwasher-Circuit-Boards-and-Touch-Pads.htm"},{"position":3,"name":"W10804120","title":"W10804120","url":""}]
You added 1 item to your cart
✖
% OFF
$
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout
