Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
September 26, 2019
Whirlpool washer adding water on drain and spin cycle. Leaving clothes soaked. When trying to spin, it will spin on low speed, then triggering flashing red light.Which load is unbalanced. When opening the top cover, i pulled the clothes from the washer, closed the cover back, and pressed drain and spin, now the water is flowing. It looks it is something related to the drum suspension ,dampner or else. Quite a mix up.
For model number WPW4900BW0
Hi Michel, thank you for your question. It sounds like your issue is that your appliance is spinning too slowly. There are a few parts to check but the first part you should look at is your belt. Those parts wear down over time and when they do your tub does not spin fast enough to expel all of the water leaving your clothes soaked. If that part is fine then you may need to go on to also check your pulley, drive hub, and your shift actuator. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Back to Top
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11703287
Manufacturer Part Number: W10780044