The door lock prevents the washer door from opening during the wash cycle or spin cycle.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Washer.
Part# WH10X20821 replaces these:
AP5958532
Customer Repair Stories
Average Repair Rating: 5.0 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
You shut the door washer would beep twice, and start button would flash.
First I locked out the power cord. I pulled the back screws to the top panel off, slid the top panel to the back of the washer, and pulled the top off. opened the washer door, and ran my down where the door switch was. with one hand on the switch, I use the other hand with a philips screw driver to remove the screws on the door switch. Pu
... Read morelled the switch up just enough to remove the electrical plug. Now installation will be the same but start backwards. Plug in the switch, run the switch into the housing. While holding the switch in place with one hand use the other hand to install the two screws. Replace the top panel, remove any lockouts.
Read less
Jerry from GRAND JCT, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
5 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kandy
October 14, 2021
My washer is not filling but I hear the water running, afterwards it goes to the wash cycle and does not spin, and then continues through the other cycle and then stop before the complete cycle. Throughout the cycles, the door will unlock, pause then lock and sometimes it freezes once unlocked. What is a possible solution?
For model number GFW450SPK0DG
Hello Kandy, thank you for your question. We have researched the model you have provided, and we would suggest the Washer Door Lock, part number PS11699522. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Hanna
August 21, 2023
The latch on my washer door broke off into the washer. I need to replace both parts and somehow remove the broken off latch
For model number GFW450SSM1WW
Hi Hanna, thank you for reaching out. The part you are looking for is the washer door lock, part number PS11699522. We have attached a video that can help you remove and replace the door lock. We hope this solves your problem!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Helena
June 12, 2023
My washer goes on. The door locks. Nothing happens then the door unlocks.
For model number GEW450SPKODG
Hi Helena, thank you for getting in touch. If the door locks and unlocks properly but still the washer does not start a cycle, we would recommend checking the control board, part number PS11721802, as it is most likely faulty and may need to be replaced. We hope this sorts out your problem!
My washer goes on. The door locks and engages. It sits for a minute. But no water starts. Then the door unlocks and it shuts off. Last time I used the washer, I washed towels. I went to get them out and they were still wet. I replaced the control board and it still does the same thing. Could the door lock sensor be bad?? Is there a way to reset this washer?
For model number GEW450SPKODG
Hi Helena, thank you for the question. Yes, we would recommend taking a look at the door lock, part number PS11699522, to see if it is working or not. To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. We hope this information helps!
Was this helpful?
Thank you for voting!
Michelle
October 5, 2023
My washer door will not close. If you hold it to seal it will start & the lock will engage, but the door is still not shut. Do I need a new lock or something else?
For model number GFWS1705H0DG
Hi Michelle, thank you for reaching out. We have concluded that the issue is with the washer door lock, part number PS11699522, which may need to be replaced. We hope this solves your problem!
