GE/GE_Thumb/00123119i03.gif
See part 217 in the diagram
( Grid squares measure 1x1 inch )

Get in touch, we're here to help!

Open until 10PM EST

customerservice@partselect.com

Door Lock Latch

★★★★★
★★★★★
2 Reviews
$ 176.58   In Stock

Get this part fast. Average delivery time via standard shipping: 1.8 days.

PartSelect Number PS1021459
Manufacturer Part Number WH10X10006
Manufactured by GE
Troubleshooting
This part fixes the following symptoms:
Will Not Start | Lid or door won’t close | Lid or door will not open
This part works with the following products:
Washer.
This part works with the following products:
General Electric.
Part# WH10X10006 replaces these:
AP3884122, 1168668
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

10 questions answered by our experts.
    Sort by:
    Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
    Steve
    August 22, 2017
    Won't spin or drain. Door locks and unlocks on its own. It spins two revolutions on drain and spin cycle, then stops. It seems like the door switch that i am looking at on your site might be the problem, but it just hasn't gone out completely. I just want you to verify that this is the right part.
    For model number WCVH6800J1WW
    Hello Steve, thank you for contacting us. That sounds like it would be the door latch. They can start to fail by randomly stopping the washer, sometimes putting pressure on the door will keep it going, but it does look like it would be the door latch. Good luck with the repair!

    2 people found this helpful.

    Was this helpful?
    Thank you for voting!
    Jeff
    August 23, 2017
    My washer beeps and adds time to the cycle when you press start and you have to move the cycle knob to reset the display back to the normal run time. If you open and close the door it will often start properly. I didn't see any sensor to replace so I am wondering if it just needs the lock replaced.
    For model number WCVH6800J0MS
    Hi Jeff, Thank you for your inquiry. I would suggest testing your door lock to see if it is malfunctioning. I would also suggest testing all of the thermostats inside of your dryer. If they are reading the incorrect temperature then the board might be adding more time to the cycle because of it. If all of those parts check out, you may have to look into contacting a repair technician to come and test your electronic control board. I hope that helps. Good luck with your repair.

    1 person found this helpful.

    Was this helpful?
    Thank you for voting!
    JANET
    September 5, 2017
    Hi, i am trying to figure out which part i need for my washer? The problem i am having is the washer powers up, however when i shut the door the button to turn the wash cycle on buzzes and then sometimes does go on briefly, but then automatically shuts off immediately. The door remains locked and you can not open it. In order to open the door you must unplug the machine to reset it and only then can you get access to open the door. Please let me know if this would be an electronic issue in the panel or if it is the part in the door frame that needs to be replaced? I am a bit disappointed in this particular machine as i have already had it worked on twice and it is only between 5-7 years old!
    For model number GFWH2400L0WW
    Hi Janet, That is a good question. If the washer is stopping shortly after it starts then you may need to replaced the door lock latch, part number PS1021459. I hope this helps with the repair.

    1 person found this helpful.

    Was this helpful?
    Thank you for voting!
    Lynn
    April 22, 2019
    Start button lights up but won't start machine. I just get a double beep.
    For model number WPDH8800J3MV
    Hello Lynn, thank you for inquiring. For this symptom you will want to replace either the Door Lock Latch part PS1021459 or the Drive Belt part PS1020114. We hope this helps.

    1 person found this helpful.

    Was this helpful?
    Thank you for voting!
    Frank
    May 30, 2019
    Trying to fix a door latch assembly. The model number on the GE washer clearly indicates that it is wbvh5100hww, but in the search feature of your site it only gives me two options of the above number....one ending in h0ww and another ending in h1ww. which would mine be?
    For model number WBVH5100HWW
    Hello Frank, thank you for writing. This Door Lock Latch is the replacement for both of the models listed.

    1 person found this helpful.

    Was this helpful?
    Thank you for voting!
    Matt
    January 12, 2018
    Door will not lock. Replaced door lock latch & door keeps beeping and will not lock to start washer?
    For model number GFWH2400L0WW
    Hello Matt, Thank you for your inquiry. Check the strike on the door to make sure that it is not cracked or broken. Also check the wiring between the latch and the control board and the main control board itself. Hope this helps!

    Was this helpful?
    Thank you for voting!
    Michael
    March 2, 2018
    Is there a way to test this with a volt ohm meter?
    For model number WH10X10006
    Hello Michael, Thanks for your question. Yes, the door lock latch can be tested with a multimeter for electrical continuity. Replace it if it shows no continuity. Set your multitester to the R X 1 scale. Place the tester's leads on one terminal each. This should produce a reading anywhere in between zero and infinity. If your multitester produces a reading of zero, or a reading of infinity, replace the latch. I hope this helps.

    Was this helpful?
    Thank you for voting!
    Richard
    August 6, 2018
    The latch on the door was replaced a few weeks ago, old one broke do to having to slam it to lock the door usual had to slam it several times. I then replaced the locking unit itself, no better it still won't lock shows locked then beeps and unlocks what else could it be?.
    For model number GEWH2400
    Hello Richard, thank you for your question! I would recommend you check the strike on the door to make sure that it is not cracked or broken. Also check the wiring between the latch and the control board and the main control board itself. Hope this helps!

    Was this helpful?
    Thank you for voting!
    Blase
    January 29, 2019
    Hi i cant find a matching door lock it only has a 3 prong male electric plug and is 5 inches long
    For model number gfw430ssm1ww
    Hello, thank you for your inquiry! We are showing your model needs part number PS11699522. Hope this helps!

    Was this helpful?
    Thank you for voting!
    Cindy
    March 28, 2019
    I am looking for a door lock assembly for a GE front loading washer. I saw you youtube video demonstrating part #wh10x10006. I wanted to be sure this was the right part for my washer. thank you.
    For model number WPDH8800JOWW
    Hello Cindy, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number: PS1021459. Thank you for your inquiry, good luck with this repair!

    Was this helpful?
    Thank you for voting!
      Part Videos

      Replacing your General Electric Washer Door Lock Latch

      Customer Repair Stories
       Average Repair Rating: 3.9 / 5.0, 4 reviews. What's this?
        Sort by:
        Sorry, we couldn't find any existing installation instruction that matched.
        Machine would not function
        Removed the three screws behind the top panel and slide it back to remove. Removed control panel then the two lower screws on the front panel the spring around the front of the gasket and slid up the front assembly to remove. Door lock was on front panel held by 2 screws and then loosened clamp around back of gasket and the gasket removed easily. The installation was easy nothing special to do and the problem was solved.
        • Andrew from Dania, FL
        • Difficulty Level:
          Easy
        • Total Repair Time:
          15 - 30 mins
        • Tools:
          Nutdriver, Screw drivers
        • Parts Used:
          WH08X10036, WH10X10006
        60 of 69 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
        "Door Locked" light always on. Washer would not run
        Remove bottom kick plate of washer. Remove 4 screws behind door that hold the latch/lock assembly. Reach up inside the washer from underneath to unplug 3 wire connectors. (This is a very tight spot). Once wires are off, part comes right out. Connect wires to the new part - this is by far the most difficult part of the job because it is way up inside the washer. Replace all bolts.
        Overall, pretty easy to do - just reconnecting the wires is a pain, but if you are patient it is not a big deal.
        • Robert from Dallas, PA
        • Difficulty Level:
          Easy
        • Total Repair Time:
          15 - 30 mins
        • Tools:
          Nutdriver, Screw drivers
        • Parts Used:
          WH10X10006
        34 of 53 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
        Washer door would not lock / run. It just beeped twice.
        Unplug the washer power cord. Take the screws off at the top (behind the front panel). Take the bolts off at the back (just the ones at the top). Remove the top cover. I'm going on memory here... Take the dial / knob off the front. Make sure the bottom of the control panel is free so the it's lip does not block the front panel (where the door is at). There may be a couple more screws to free the control panel. Take the panel off the front of the bottom (just above the pedestal if applicable). Take the screws out at the corners of the front panel (where the door is at). Open the washer door and take out the screws to free the front panel. The front panel is also hooked on brackets, so you will need to slide it up a little bit to take it off. Be careful of the rubber seal, because it will still be attacked to door (you might want someone there to help hold it). You just need enough room to get that door lock latch outta there. Remove the screws holding the door lock latch, and pull it out of there just enough were you can disconnect the wires. Connect the new door lock latch, put it back in place and then put the screws back in. Remember the brackets on the front panel. Once you get that panel back in place, continue the re-assembly. As for the door plunger, there are only 2 screws holding it on the door side. Do everything slow and carefully, and it should work out ok.
        • Elliot from North Port, FL
        • Difficulty Level:
          A Bit Difficult
        • Total Repair Time:
          15 - 30 mins
        • Tools:
          Pliers, Screw drivers
        • Parts Used:
          WH01X10255, WH10X10006
        34 of 57 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
        Door Latch Failure Code
        Unplug machine.
        Remove band from front bellows by prying the spring at 6:00 o:clock loose.
        Pull back bellows on right side.
        Remove 3 torx screws and gently pull door each lock assembly out. Unplug 3 wire harness connectors and plug into new latch lock in same order.
        Screw new latch lock in place and replace bellows and band.
        Done
        • John from BOULDER, CO
        • Difficulty Level:
          Really Easy
        • Total Repair Time:
          15 - 30 mins
        • Tools:
          Screw drivers
        • Parts Used:
          WH10X10006
        3 of 3 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
          Customer Reviews
          Average Rating:
          ★★★★★
          ★★★★★
          2 Reviews
          5.0
          Filter By Rating:
          • 5 Stars
            2
          • 4 Stars
            0
          • 3 Stars
            0
          • 2 Stars
            0
          • 1 Star
            0
            Sort by:
            Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
              Model Cross Reference
              This part works with the following models:
              PartSelect Number: PS1021459
              Manufacturer Part Number: WH10X10006
              Brand
              Model Number
              Description
              General Electric
              GBVH5140H0WW
              Washer
              General Electric
              GBVH5140H1WW
              Washer
              General Electric
              GBVH5200J0WW
              Washer
              General Electric
              GBVH5200J1WW
              Washer
              General Electric
              GBVH5200J3WW
              Washer
              General Electric
              GBVH5200J4WW
              Washer
              General Electric
              GBVH5200K0WW
              Washer
              General Electric
              GBVH5300K0WW
              Washer
              General Electric
              GBVH5300K2WW
              Washer
              General Electric
              GBVH6260F0GG
              Washer
              General Electric
              GBVH6260F0WW
              Washer
              General Electric
              GCVH6260F0GG
              Washer
              General Electric
              GCVH6260F0WW
              Washer
              General Electric
              GCVH6260H0WW
              Washer
              General Electric
              GCVH6260H1WW
              Washer
              General Electric
              GCVH6400J0WW
              Washer
              General Electric
              GCVH6400J1WW
              Washer
              General Electric
              GCVH6400J2WW
              Washer
              General Electric
              GCVH6500K0WW
              Washer
              General Electric
              GCVH6500K1WW
              Washer
              General Electric
              GCVH6600H0BB
              Washer
              General Electric
              GCVH6600H0GG
              Washer
              General Electric
              GCVH6600H0MB
              Washer
              General Electric
              GCVH6600H0MS
              Washer
              General Electric
              GCVH6600H0WW
              Washer
              General Electric
              GCVH6600H1BB
              Washer
              General Electric
              GCVH6600H1GG
              Washer
              General Electric
              GCVH6600H1MB
              Washer
              General Electric
              GCVH6600H1MS
              Washer
              General Electric
              GCVH6600H1WW
              Washer

              Get in touch, we're here to help!

              Open until 10PM EST

              Contact Customer Service