Knob - Stainless W10766544

Hello James, Thank you for the question. Very sorry but the D shape clip is not sold separate from the knob, PartSelect Number PS10067059. In order for the clip to be replaced the knob will need to be ordered. Thank you for your inquiry, good luck with this repair!

Good Day Zlatko. Thank you for your question in regards to PartSelect Number PS10067059. Based on our research, this is for one knob and not a set of four. You can order this part either online at our website www.PartSelect.com or by calling us by phone at 888-260-4310. Best Regards.

Hi Nafisa, Thank you for your inquiry. The knob just slips on to the shaft of your switch. You just push it on and you can pull it off. I hope that helps. Good luck with your repair.

Hi Nafisa, Thank you for the question. The knob just slips onto the shaft. Line up the D shape in the back of the knob with the D shape on the shaft that comes out from valve behind the panel and push it on. Hope this helps!

Hello Stephane, Thank you for your inquiry. This is just a blank knob. Hope this helps!

Hi Homer, Thank you for the question. No the D shape does not spin. Hope this helps!

Hi Martha, Thank you for the question. We are not able to send pictures through the question and answer section of the site but if you go to the link below it will bring you to a picture of the knob. You can also google image the manufacture part number W10766544. Hope this helps! http://images.parts-bay.com/remote/DigitalMedia/wpl/wpl-w10766544/wpl-w10766544_range_control_knob-default.jpg?width=1000&height=1000&mode=crop

Hi Daniel, Thank you for your question. the cost would be for one knob. They are sold individually. I hope this helps. Thank you and have a great day!

Hi Joseph, thank you for your question. This knob is sold individually. I hope that helps. Good luck with your repair.

Hi Cheryl, Thank you for your question. A normally functioning igniter will typically click up to three times before it sparks. But, every now and then you may run into instances where the ignitor continues to click or tick even after the burner is lit, or the burner never lights at all. A clicking ignitor typically is not dangerous and may continue to click if the gas is shut off. One of the most common sources of this issue is that the Burner Cap is out of place. Make sure the cooktop is completely cooled and remove the Burner Grate to access the cap. Try removing the cap and center it on the base. If the burner cap is askew, it can prevent the burner from lighting. If that doesn’t work, check for moisture. If you recently had a pot boil over on burner, a food or grease spill, or cleaned the cooktop, there may still be moisture present even if it looks dry. Remove the burner cap and give the burner time to air dry. To speed up the process, make sure all the burners are off and towel off the top of the range. You can then either use a fan aimed at the range top or set your oven to 350° and leave it on for around 30 minutes to speed up dry time. If you see that there is debris stuck in the holes in the burner, that could also potentially be the culprit. You can use a metal pin or paper clip to clear the debris out of the grooves. Never use items such as toothpicks to do this, they may break off and get lodged inside. If you get through all of these tips and still have the clicking problem, it may be the Spark Module, Spark Ignition Switch or the Ignitor itself. You can find replacements for your model stove for purchase on our website. If you feel comfortable, this is a repair you can do yourself. But, if you’re ever unsure don’t hesitate to contact a technician and consult your owner’s manual. If you need to replace the knob, the part number listed under your model number for the knob is PS10067059. I hope this helps. Thank you and have a great day!