RACK ASSEMBLY 5304498212

Just out the old and slipped in the new

The repair was SO SIMPLE!! No tools required. Unsnapped ends of top rack & removed old rack. Took top sprayer assembly from old rack & snapped it in place on new rack. Inserted new top rack into slider rail and closed ends. Inserted bottom rack, and job was done.

First, I was so pleased to find these parts at such reasonable prices! Sure beats replacing a dishwasher in terms of money and labor. I'd already studied the online instructions a couple times before ordering and checked to make sure my racks dis-assembled as shown. They did, I ordered, got the new racks within days and installed both in under ten minutes. Great service and awesome installation videos. I will definitely check this site if I need replacement parts for anything else in the future. THANKS so much!

Took out old. Put in new.

Just watch installation video. Finished repair in abut 30 minutes. Honestly, great service and fast delivery from this company. Please add the contact info to your favorites

I thought these were OE racks they are not. They did do the job. However, I like OE parts the difference is exactly where the fold over rack on top rack goes the tines were not there to clip on it into there was a larger gap. So it was almost the same except the most important area. Same for the cone that clips in the center of the top rack. It is not as tight a fit front to back as it should be so it moves around more. I was concerned that the jet of water from top would miss the cone but it seems to be ok. So far so good. The racks did the job dishwasher is still cleaning dishes. But aftermarket parts are almost the same just not quite the same.

took out the old racks - put in the new racks... only had to move one part from old to new on upper rack assembly.. easy! and quick -- I'm over 60 - female - arthritis in my hands -- and I could do... so can you!

The parts came very quickly and the lower rack just slid in after sliding the old one out. The upper required removing the end stops and removing the rack. The water spout in the middle had to be removed, twisted off and then popped the holder for the spout off and attached it to the new rack, rolled the new rack in and replaced the end stops. This was done by my wife!

I WATCHED THE VIDEOS. EXCELLENT HELP.

Ordered a new upper rack, My husband installed in less than 10 mins. Good to go. So easy.