This 115-volt 60Hz evaporator fan motor is located in the back of the freezer and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. If the motor has failed, the freezer/refrigerator will become too warm because the fan motor is not circulating the cool air from the freezer into the refrigerator. This is a genuine OEM part. Please remember to disconnect the power to the appliance before starting your repair.
How Buying OEM Parts Can Save You Time and Money
Part Videos
Replacing your General Electric Refrigerator Evaporator Fan Motor
Troubleshooting
This part fixes the following symptoms:
Noisy | Fridge too warm | Freezer section too warm | Will Not Start
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Joseph D - November 22, 2023
Verified Purchase
Easy Repair
The motor received didn't look exactly the same, but had all the right connections and went in easily. I figure I saved $200 by doing it myself
★★★★★
★★★★★
Susan M - July 20, 2023
Verified Purchase
great part
Part got here fast, took a short time to install, back running in less than 20 mins. I found this to be a good store, found what I needed fast. I also found many other things I could order if and when needed. Main thing is finding this part so fast and so easy to install.
★★★★★
★★★★★
Omar M - May 17, 2023
Verified Purchase
Great part great cost
Exactly what I needed. Not an OEM replacement, but definitely same specs and all measurements made the job a quick one. Thank you
★★★★★
★★★★★
Wesley W - May 13, 2023
Verified Purchase
Saved me money!
Part made little bit different but worked perfectly! Repair took about 30 minutes to complete. Quick delivery.
★★★★★
★★★★★
John R - March 17, 2023
Verified Purchase
Great part
Motor worked as intended. Pleased with purchase
★★★★★
★★★★★
Dennis B - January 20, 2023
Verified Purchase
Easy peeze
Part fit perfectly. Unit was running in 35 min
★★★★★
★★★★★
David N - January 12, 2023
Verified Purchase
Satisfied customer
The part was a perfect match. Easy install and got refrigerator back in service in no time!!
★★★★★
★★★★★
ROBERT T - December 15, 2022
Verified Purchase
Replace noisey evaporator fan motor.
The evaporator fan motor was in perfect condition and an exact replacement.
★★★★★
★★★★★
Kenneth C - December 14, 2022
Verified Purchase
Easy purchase, quick delivery, easy repair
The motor works fine, easy to install. The motor is quieter than the original one when the original was new.
★★★★★
★★★★★
CHARLES M - October 30, 2022
Verified Purchase
Perfect fit
Easy to install much better than the original.
< Prev
1
2
3
Next >
Customer Repair Stories
Average Repair Rating: 3.9 / 5.0, 47 reviews.
What's this?
Sort by:
< Prev
1
2
3
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Refrigerator fan motor died
It has been my experience that these motors sometimes die when the refrigerator is overfilled and motor strains to keep refrigerator cold. And this motor is used in several models of refrigerators. That said, sometimes the hook-up is slightly different between other units. The available video is good, but like I said, circumstances wil
... Read morel be slightly different between various models.
After cleaning out freezer (plug disconnected first), start to remove outer plastic covers. If you want to keep track of the different steps, you can take pictures with your cellphone. And if there are any connecting wire attachments you think you might not remember, again, you can take a picture, or label with tape (colored tape, or by writing on the tape). And for keeping track of the different-size screws, I place them in a muffin tin, keeping an order of left to right and top to bottom in the tin. When removing Styrofoam blocks in bottom center, make sure you remove any remaining ice underneath in the hole so refrigerator can "breathe". Freezer air is moved below to refrigerator compartment, so a blocked vent hole will strain refrigerator as it tries to maintain its temperature setting and can be the cause of your failed motor.
After replacing motor onto bracket with grommets and blade, don't completely tighten. Position plastic cover with hole opening over motor and blade assembly. Twirl motor blade to see if there is any interference with cover. If not, take away cover and tighten motor on bracket. If there is any rubbing, adjust motor/blade assembly accordingly before tightening in place. Putting everything back together is in reverse order.
Fast and easy-great video instructions for each part ordered. All parts perfect fit. My refrigerator is running like new again-good for another 10 years!
Open freezer, remove rack....this got a little complicated because I had to remove the door, that required the offset screwdriver because I had a clearance issues preventing the door from opening all the way. Remove the panel covering the fan, unplug the fan, remove it from bracket, install new fan, plug in, replace panel, replace rack, r
... Read moreeplace door...bam all done!
Read less
Gregg from COEUR D ALENE, ID
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Loud screeching noise from freezer during cooling cycle
I replaced the fan motor and one of the grommets. When I took the motor out it was clear it was failing because there were metal flakes from the motor on the fan blade. I followed the instructions on the posted video. My model did not have a removable bottom tray in the freezer so that was one less thing to do. Aside from that the vide
... Read moreo was accurate. I had two minor problems during reinstallation. First, it was very difficult to get the spring clamp back on the fan blade without pushing it against the motor. Recommend you get someone to help hold the spring open while you push it on. Second, the length of wire on the replacement was not exactly the same as the original and I had to move some wires around. Recommend you take a picture of the cable layout before disassembling.
the evaporator fan motor was making noise sometimes, but not all the time during the cooling cycle
after watching how easy it was to get to the evaporator fan motor on u-tube, I took out the motor to inspect it......the motor had about 1/8 inch shaft end play and a slight amount of play on the shaft, the rubber grommets looked OK.....I then put it back together......since the motor was the only moving part in this location I figured it
... Read more had to be the part making the noise, so I ordered a motor and 2 grommets …...the replacement motor also had 1/8 inch end play on the shaft, but no play on the shaft....I installed the new parts and it has been a week now and no noise.....SUCCESS!...….the shaft on the motor protrudes from the motor, and the fan is mounted about 1 1/4 inch away from the bearing in the motor and the fan is unsupported, so I ASSUME that the slight amount of play on the shaft caused some harmonics which caused it to make noise some of the time, but not all of the time......
Freezer was wet and there was no air coming out of the freezer fan. Unit was very noisy too.
The video that was attached to the part order was good, but not exactly the same as my unit. One thing I recommend is that you cover up the drain below the evaporator coil with a piece of paper and tape it down, because as I was putting the motor back I dropped a screw and it fell down the drain. So I had to go buy a new screw. Gi
... Read moreve the cost of a repair man coming to fix a refrigerator that cost only $450 to begin with, doing this repair was well worth my time. (But I also had another refrigerator to move things to and could take my time and wait while they replaced the faulty part they shipped me.)
First unplug freezer and empty contents, then remove the screws from the air deflector, carefully remove styrafoam air deflector block then remove back panel for easy access. Fan will be easy to switch out from there. I highly recommend the You Tube video which is where I got my basic instructions.
Ask our experts a question about this part and we'll get back to you as soon as possible!
10 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Peter
June 20, 2022
Is there an easy way to tell if I should replace the evaporator fan? The refrigerator only cools to 50 degrees. I vacuumed and checked the condenser area, but no change. I think I have a broken evaporator fan. Thus the question.
For model number HTH17CBTZRWW
Hello Peter, Thank you for the question. If the fan is not spinning or spinning slowly, the Fan Motor will need to be replaced. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Carrie
December 11, 2022
My fridge is too warm but the freezer is cooling fine. I pulled apart the top and have the fan assembly exposed. Should I be able to observe the fan running when I have the door to the freezer open? So far I have not seen it running. If it is not running, then is the fan motor the only part you foresee me needing from this assembly? Thanks!
For model number GTE18LGHBRBB
Hi Carrie, thank you for reaching out. Yes, the evaporator motor appears to be faulty and you may need to replace it with part number PS12741350. We hope this information helps! If you need help placing an order, customer service is open 7 days a week. Thanks again for your great question.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Virgil
July 27, 2023
My refrigerator is not working properly the freezer will freeze ice but the refrigerator is not getting cold enough the fan that moves the air to the refrigerator compartment is running but I don’t know if it is running fast enough or if it may be a two speed fan and something is keeping it from kicking into the higher speed?
For model number Gts22jcpdrww
Hi Virgil, thank you for the question. You may need to check the defrost thermostat, part number PS1155320, to fix the issue. It protects the evaporator from overheating during the defrost cycle. If it is faulty, it causes a rise in the temperature of the refrigerator. We hope this helps!
Will this part WR60X31522 fit my refrigerator?
If not can you please let me know what part would replace my evaporator fan motor?
For model number gts16dthjrww
Hello Jeff, Thank you for your inquiry. We have researched the model number you have provided and confirm that this part will fit your model. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Sandi
December 2, 2022
My freezer has suddey started to make a LOUD whining sound every 15 minutes or so. Is this fixBle?
For model number HTS17GBSARWW. 1791581. 48225
Hi Sandi, thank you for reaching out. According to our research, we would recommend checking the Evaporator Fan Motor, part number PS12741350, and the Fan Blade, part number PS1018129, to fix the issue. If you require assistance placing an order, please contact customer service. We hope that helps!
Fan in freezer is make a rattling noise, does the whole fan and motor need. To be replace?
For model number GTS18HGNRWW
Hello Jeffrey, thank you for your inquiry. We would recommend checking the evaporator fan blade, part number PS1018129, to fix the issue. Please contact us anytime if you require further assistance!
Loud rattle sound coming from the freezer area. Seems to be coming from the evaporator fan motor area. Would this normally be a bad fan motor? Or should I test further before ordering parts?
For model number GTS18HGNDRBB
Hello Neil, thank you for contacting us. Based on our understanding of the issue, we would suggest checking the evaporator fan blade, either it is damaged or worn out. If this is not the issue, we would recommend replacing the evaporator fan motor, part number PS12741350, to fix the problem. We hope that helps!
Was this helpful?
Thank you for voting!
Nick
December 13, 2023
CAN I USE EVAPORATED FAN MOTOR TO THE REFRIGERATOR
For model number GTH18GBDERCC
Hello Nick, thank you for the question. According to our research, the evaporator fan motor you have mentioned is compatible with your model. You can use it in your refrigerator. We hope this helps!
Was this helpful?
Thank you for voting!
Nichole
December 22, 2023
I ordered the evaporator fan motor WR60X31522. I just want to make sure about the ground wire. My previous motor the ground was seperate. The new one the ground wire is with in the plug with the other wires. Therefore I am assuming that I don't need the single ground wire attached to the mounting terminal bracket any more. Is that correct?
For model number GTS18FBRERWW
Hi Nichole, Thank you for asking. Yes, you would be correct. Good luck with the repair!
Was this helpful?
Thank you for voting!
Shawna
2 days ago
should the metal piece on the evaporator fan motor that the blade goes on, should it be loose or firm?
For model number GTS17BBSARBB
Hello Shawna, thank you for getting in touch. According to our research, the evaporator fan motor shaft should be firmly tight. We hope this information helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
