ZGU48N6DH5SS General Electric Cooktop - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
old switch would not turn off
remove c clip, remove two wires
install new switch,
replace c clip, replace two wires
test
have a cup of coffee
install new switch,
replace c clip, replace two wires
test
have a cup of coffee
Parts Used:
-
NORMAN from THOMSON, GA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
12 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
inability of igniter to shut off
-
Darren from Redondo Beach, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
insert burner is broken
-
sherry from Raleigh, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken gas line & missing cap
Front control panel must be removed but left hanging on wires, remove kick panel at base of stove, locate and remove all screws that attach side of stove (either side) when all screws have been removed from side panel you can lift up about an inch and remove side panel thus giving you access to base of burners and attached gas lines; after replacing gas line i recharged the lines with gas and checked for leakage by using a grill lighter, (no leaks?) i re-installed the side panel, this was the most difficult part of the repair because the side panel must be properly placed and lined up
Parts Used:
-
Frank from Jacksonville, FL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!