Models > ZBD6880K10SS > Instructions

ZBD6880K10SS General Electric Dishwasher - Instructions

All Instructions for the ZBD6880K10SS
196 - 210 of 355
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
missing screw for Spray Arm
Remove top rack stops, slide out upper rack from rack railing, turn over upper rack and attach spray arm using spray arm bearing and screw. Reassemble in reverse order.
Parts Used:
SCR B-16 HXW 1/2 Stainless Steel Screw 8-16 hxw 1/2 Stainless Steel
  • Russell from Rosharon, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The wheels on the R.H. side, lower rack were broke
The wheels on the lower wash rack had fallen off. I had tried to re-install them, but they kept coming off. I ordered new ones and they came very quickly. I removed the old wheels and studs and replaced them with the new ones. (make sure you order studs because these are the parts that failed) The new studs have a design change and should last much longer than the original.

The new wheels simply snap onto the new studs, and the whole assembly snaps onto the wire "axle" on the wash rack. It's a simple fix, and well worth the few dollars it cost to buy them.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • Curt from Lake City, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Axel Broken
Easy to install - there has been a modification of the axel since original which will make it last longer. 15 Secods to install.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • DAVID from NORFOLK, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All wheels on dishwasher rack were defective
Replaced worn wheels with new ones from your company. After months of wrangling with the dishwasher peace reigns in the kitchen. Great service. Told all my neighbors about PartsSelect.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • kathleen from Washington, DC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Needed lower dish rack wheels and the local guys wanted $11.95 and PartSelect had them for $1.97 So I bought additional spares.
Less than 15 mins
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • Jon from Chelan, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wheel Slide Down On The Heat Coil
Pulled the bottom rack out. Took the back wheel out on the right side which was disfigured because it must have touch the heating coils. Examined the other 7 wheels and they appeared to be in good shape. I put the axile thru the center of the wheel and forced it on the rack-rod. It seemed to click into place. I put the lower rack in the dishwasher and it went smoothly back and forth. I have a spare just in case this happens again.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • Robert from Lake Forest, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher was missing a few elements . . .
Ordering was a breeze, the diagrams made it simple! Parts were ordered, parts were shipped, received and installed. Wonderfully easy.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Silverware Basket Upper Rack End Cap Dishrack Rollers and Axles - Kit of 8
  • caroline from Flagstaff, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dishes wre not getting clean
I handed the parts to my husband and asked him to do it.
Parts Used:
Detergent Dispenser with Rinse Cap CONDUIT CARRIER MID Spray Arm Support SCR 8-10 PL TRP 1/2 S BRACKET DETERGENT DISPLA
  • Deborah from Escondido, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers, Socket set
7 of 27 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rate chewed drain hose up.
Removed screws that held dishwasher under cabinet...pulled out DW...removed old part...replaced with new....easier than falling off a stump.
Parts Used:
Drain Tube Kit Fine Filter Hub Nut CLAMP
  • Christopher from St Augustine, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
8 of 30 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The wheels on the lower rack of the dishwasher would fall off or bend so that they no longer could support the rack.
I removed the old wheels. Then, I snapped the new axis in on each new wheel. Next, I pushed and fastened the wheels onto the dishwashers' lower rack.
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Silverware Basket Dishrack Rollers and Axles - Kit of 8
  • Connie from Boonton, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Top rack was getting stuck when sliding out.
Pulled out the rack installed new slides, rollers and endcaps,It was a snap !
Parts Used:
Cage Roller Bearing Assembly Upper Rack End Cap Upper Rack Wheel Upper Rack Wheel
  • Karl from Ke West, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
5 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
GE Monogram Dishwasher Silverware basket bottom broken on bottom
Replaced identical basket. Service was outstanding from Part Select. Basket was delivered in less than 24 hours from time of order. Truly amazing.
Parts Used:
Silverware Basket
  • Eddie from Boston, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Old wheels would not stay on (clips were worn)
Took out lower rack, turned upside down on flat surface, popped off old wheels. Pressed new axle into new wheels and snapped them directly to the lower rack.where old wheels were attached. A slam dunk..
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • Robert from Clayton, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
tear in the tub gasket
Pulled out the old gasket and replaced with the new gasket. Inserted the steel spring clip into the ends of the gasket. Repair complete.
Parts Used:
Tub Gasket
  • Edward from Granite Bay, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Original Lower Basket Wheels or Axle Broke
Remove empty basket from dishwasher. Place basket, flipped over, on a flat surface. Pre-insert axle onto wheel before attaching to basket. Snap assembled axle and wheel onto the support pin. Replace in Dishwasher. PartSelect provided outstanding Customer Service!
Parts Used:
Dishrack Rollers and Axles - Kit of 8 Dishrack Rollers and Axles - Kit of 8
  • Stephen from Ottumwa, IA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ZBD6880K10SS
196 - 210 of 355
Back to Top