YGH8155XMQ0 Whirlpool Microwave - Instructions

Arrived in 24hours!!! Great.

Removed the old vent which had been taped in place, installed the new one, took less than five minutes to do the repair. Perfect fit. Also, I ordered the vent on Monday and it arrived on Tuesday. Fantastic!

Removed the two philips screws installed new grill and replaced the screws.

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey

Tray arrived in a short period of time and was a perfect match.

Removed 2 screws that were holding broken plastic tabs. Lined up lower plastic tabs on new grille into slots, gently. Tipped forward to engage upper tabs into slots. You need to "gently" press the top into place to avoid breaking off the tabs! Replace 2 screws, and hand tighten with Phillips screwdriver. Easier to see what you're doing with the microwave door "open". I felt "accomplished" for a 70-year old Grandma.:)

removed perimeter screws from the bottom side and the lower cover is hinged at the wall side. Motor is visible and easily removed with two screws. Take of the old one, install the new one, and reverse the procedure to put the bottom cover back in place. Will nee helper to hold one side of the bottom until couple of screws can be put in on the other side.

Wedged grill into open space and screwed in with existing screws

Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)

Remove old filter & insert replacement filters

Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.

just replaced the filters

Removed microwave case and bad part was right there in plain sight attached to the magatron. Two screws and two wires and part replacement was done. Plugged in microwave and works perfect. Couldn't have been any easier. Thanks for the easy troubleshooting and parts suggestions on your site.

With a phillips head screwdriver I removed the screws, which were screwed to the then non-existent grille, at the top of the grille holder, GENTLY popped the new grill into place and replaced the screws. It took about five minutes. As a housewife, I feel that doing these little repair jobs around the house saves my husband time and aggravation. It was all very simple, and I got the ordered part in two days. Fabulous!

Removed the glass cover and replaced the bulb. Very simple.