WWSS2601KW1 Crosley Refrigerator - Instructions

Pulled door seal put and pushed in new seal, icing formed on fridge side lower return vents, had to fully chip away, compressor running and stopping as normal.

I used a flat head screwdriver to pry open the front of the socket as I pushed the socket toward the freezer side. I unplugged the two wires connected to the socket then re-connected the two wires to the new socket and popped the new socket back in. I then put a new light bulb in and we had light again in the fridge.

It was pretty easy. The hardest part was getting the supports that had snapped off out of the walls of the refrigerator. Once that was accomplished it was a breeze.

removed the old parts with a philips screwdriver then repalced those parts with the new parts and knocked the keeper inwith the small hammer

This is an easy repair. Unplug appliance. Remove the old water valve by unscrewing it from the frame of the refrigerator. Disconnect the cables and all the water hoses. The hose fittings are a different type: clip off the old connectors from the hose ends and push the hoses straight into the new connectors till they fit solidly. Reconnect the cables and screw the valve back onto the frame of the refrigerator.
Unfortunately, my leak was from a hose, not the valve, so this didn't actually fix it.

took existing water valve loose, removed plastic water lines and reinstalled on new valve and installed new valve into refrigerator

I just put pressure to put the parts on place

Very easy repair. Simply remove the the broken drawer cover frame and replace with the new. Took longer to clean the glass than it did to replace the frame.
The door shelf bin just slid into place.

I took old shelf out and put new shelf in. No problem.

I read the instructions/comments on partselect.com and go to work. I removed the spill tray, then three screws. This allowe me to pull the faceplate of the ice and water actuators forward.
After a little adjusting I could see the two screws which were holding the actuator in place.
I had to be careful here a the comments listed the ease in dropping these smailler screws. I magnteized my screwdriver before attempting.
I undid the screws, and removed the actuator. The new one was easy to put into place. I simple then reveresed the process which I had folled to get here and voice, less than 15 minutes a new water actuator.

Part snaps in door in less than a second. No problem.

Water was leaking so I replaced the entire valve and just followed the color codes and thats it. Plug and play.

Just snapped it into grooves on the door

No big deal, just easy service and next day delivery at the 3-5 day price

I pull out the broken part by push the center pin thru and then rerome all the parts. I then positioned the new part in place and push in the center pin to lock. quick and easy.