WWSS2601KW0 Crosley Refrigerator - Instructions

removed the old one & put the new bin in

Turned off the water supply ,pulled the plug removed two screws to access theater lines the new valve body was a little different than the original I had to cut off the end of each hose and push them in to the new connections the hoses are size and color coded replaced the two screws put the water line on plugged it in and turned on the water checked for leaks twice and replaced the back cover

Open package slide new bins in. That easy

I simply replaced the broken drawer/pan guide and installed new pan/drawer. No tools needed as the parts literally slipped in place.

After removing the lower section which just snapped out I went to remove the three screws on the bottom of the water/ice dispenser. The only problems I had we're here in that the screws were rusted and difficult to get out with water falling into this area over time. Then I easily removed the three screws holding the motor and actuator. Of course there was three more screws holding the water dispenser actuator in place. I took the broken piece out and put it all together again but placed some rust resistant screws I had to replace the three rusted screws. Works great!

service was great-got filter promptly- on line instructions very helpful. showed how to turn off water, remove filter and replace with new one. no problems.

Used needle nose pleirs to slide the old fan off.Then slide the new fan on the spindle.The video really made this easy!

Went on your website, originally ordered wrong part, upon discovering my mistake you immediately voided that purchase and then I ordered the correct part. Very professional and easy.

ice maker= replaced overload,microswitch and solenoid water valves.refrigerator=replaced the thermostat.Great price on parts,very fast delivery and parts were a perfect fit.You made the job very easy. John

Removed the ice maker cover on the front (6 screws)...took off old parts and installed new ones....very easy... replaced front cover and no more frost build up in the freezer.

Because of the design of the support, this could have been a difficult job. However, with the video that was provided when I selected the part, it was not a problem. All you have to do is knock the center pin through the support and remove the old support. Pull the pin out of the wall of the unit and push the new support in and drive the new pin in until it is flush. That's it!

Unload shelve, took out, replaced done.

Repair was easy and fast. Just slide the cover to the back and snap the front, less than 10 seconds and it fits perfectly.

Three very easy to get to 5/16" x 3/8" bolts to remove cover and mount. Elbows were tooless push to release type. Elbows removed in seconds from old housing. Elbows simply pushed on to nipples of new housing. Same three bolts to remount and done!

It was so easy, i did it myself, also the help of a you tube video from Partselect. I was so proud of myself even though it only too less than 15 minutes to fix. Now no more wet towels laying around. thanks so much for your help.