WRS23MW3AWE Westinghouse Refrigerator - Instructions

After watching an on-line video, the actual repair was easy.

Removed top hinge, lifted door off, replaced lower hinge bracket and cams. Replaced door. Part fit perfectly in spite of a design change. No more annoying popping noise.

We watched the video on the computer how to repair and install the hinge bearing, followed the instruction, and the repair job was done successfully and easily without any further problems.

moved freezer items to right of icemaker,loosen two nuts lifted icemaker over nuts,squeezed and pulled cable out turned over marked L bracket screw with marker for location plugged cable in tighten screws,made ice in 2 1/2 hours john

The two screws that held the ice maker in place could not be seen do to there location. I could only get one hand inside do to space restriction.So I placed a mirror inside so I could see the screw heads and from point it was very easy to see and line up the nut driver on the screw heads. I then lifted it up and unplugged the wiring and installed the new ice maker. Works like a charm. Paul

1st a changed the defrost stat. Waist of time. Realized there was no evaporator above fan. Noticed ice was builing up behind ice maker near fill tube. Found if I shut off ice maker ice wasnt building up on fan. Moved fridge out unplugged fridge unscrewed plastic nut. Turned 90 degrees. Replaced tube locked in place . Screwed nut back on . Plugged in and turned ice maker on. Wife happy ice was back on and no noise.

followed the video instructions and wa-la! Saved my money by not calling the repair man, the shipment of my part was fast, and the repair was even faster. Thank you for helping me in my repairs. Very Satisfied!!! Carol

Removed the right door. Removed three bolts that hold on the door on. Once removed, I removed the bushing with a screw driver and popped the new one in. Replaced the door and no more noise. Fixed the problem. I also watched a you tube video before I started.

The refrigerator comes with 4 door bins. I had alot of wasted space so I purchased and installed another door bin. It snapped in. The hardest part was unsnapping a couple of the other bins to reposition them for better use.

Took every thing out of the door, removed 2 screws (plus cover screw), laid the door down, replaced the parts, put the door back on. When the refrigerated stuff was back in the door shelves, I was done.

The broken bin was removed. It lifts out. And the new bin slipped into place!!

As per video. No problem.

Watch the video provided by PartSelect and did exactly the same percedure. Shows what screws to remove and how to remove and replace the part. The freezer compartment was iced up quite a bit so defrosted it before installing part.

First off, I ordered the wrong part. Following the "return" protocol, , Partselect, UPS had the correct part delivered to me the next day. The instructional videos linked to the part description made my repair effortless. A great resource for DIY's.

first turn power off (i just tripped breaker but you can unplug unit. Next remove water and ice base tray this piece simply slides straight out. Now remove the control panel bezel by first removing 3 #2 philps head screw along base of bezel, unplug bezel/control panel from actuator by removing 12pin connector set control panel/bezel aside for now. next remove 3 screw securing ice and water dispenser, remove 4pin electrical connector on lower left side. now aqloow unit to hang by water supply tube . rotate unit so that you have a top view. visually locate and remove the two metal keeper that hold the dispenser actuator in place again there are 3 philips head screws holding these tabs down 2 on one tab and one on the other remove and discard old/broken tab. install new actuator and reverse the removal process and your done the whole job takes about 15-20 miniutes unless you have to repair any rusty area that can form around face of refrigerator face where bezel mounts.