Circulation Pump and Motor WPW10510666

Hello Justin, thank you for contacting us. Yes, if this part is faulty it would not circulate the water properly or at all. The chopper is located in the pump-motor assembly. Hope this helps!

Hi Mark, Thank you for your inquiry. If the dishwasher is not spraying water, then you will need to make sure there is proper water pressure. Turn the tap on first to make sure there is good water flow. If there is good water flow, then you will need to check the water inlet valve, the filter, the turbidity sensor, the lower spray arm and the middle spray arm. I hope this helps. Thank you and have a great day!

Hello Bill, Thank you for your question. The turbidity sensor is locate on the side of the sump assembly and can be accessed by removing the panel underneath the dishwasher door. The sensor can be removed by turning it counter clockwise about a half rotation, and pulling it from the unit. There will be a wire harness attached to it, and by depressing the tab you should be able to remove the wire harness by pulling it out of the sensor. You can test the turbidity using the field service test found in your owners manual. Hope this helps!

Hi Dave, thank you for your question. First you should check all of your tubes and arms for any blockage as it sounds like water is not pushing through strong enough and blockage can stop that. You may want to check your filter as well. If those parts are fine then it is likely your pump that is the issue. Good luck with your repair.

Hi Quince, the only way to be sure a part will fix your issue is to hire a local technician to take a look. You can try and clean the filter and pump, you would have to disassemble the pump to do this properly. Thank you for your question and good luck with your repair!

Hello Justin, thank you for contacting us. Yes, it would be located in the pump motor assembly. Good luck with the repair!

Hello James, thank you for contacting us. The most likely causes of this combination of symptoms are the Heating Element part number PS8260087 or the Drain Pump part number PS11753379 for your model. You may need to replace the Dispenser part number PS11756691 for the soap pack not dissolving. I hope this helps and good luck with your repair!

Hello Rhonda, Thank you for your inquiry. We have researched the model number you have providd and would recommend checking the following parts to fix your issue: the circulation pump and motor, and the water supply tube. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Michael, thank you for writing. We believe it to be the Electronic Control PS11722936. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.

Hello Kevin, Thank you for the question. This is normally an indication the Circulation Pump and Motor is faulty. The Circulation Pump is separate from the Drain pump. It is responsible for circulating the water to the spray arms during the wash cycle. The Water pressure may effect the Water Inlet valve but will not effect the circulation pump. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!