TCD1870QGS LG Dryer - Overview

Sections of the TCD1870QGS

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
4 PACK ROLLER ASSEMBLY – Part Number: 4581EL2002L
4 PACK ROLLER ASSEMBLY
★★★★★
★★★★★
(71)
PartSelect #: PS17269866
Manufacturer #: 4581EL2002L
This part is sold individually. The drum support roller is found in your dryer. It is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. It is recommen...
$135.77
  In Stock
Dryer Thermistor – Part Number: 6323EL2001B
Dryer Thermistor
★★★★★
★★★★★
(4)
PartSelect #: PS3529026
Manufacturer #: 6323EL2001B
This dryer thermistor temperature sensor helps monitor and regulate the temperature inside a dryer. This part includes the wire harness. If your dryer overheats, does not produce enough heat, or takes...
$70.77
  Special Order
Blower Thermostat – Part Number: 6931EL3002M
Blower Thermostat
★★★★★
★★★★★
(7)
PartSelect #: PS8747887
Manufacturer #: 6931EL3002M
The thermostat is a part for your dryer, and it is roughly 1 inch long by roughly 1.5 inches wide. The purpose of the thermostat is to measure the temperature of the air inside your dryer drum. As the...
$45.88
  In Stock
SWITCH ASSEMBLY,SAFETY – Part Number: EBF61496102
SWITCH ASSEMBLY,SAFETY
★★★★★
★★★★★
(7)
PartSelect #: PS16551445
Manufacturer #: EBF61496102
$40.39
  In Stock
Pulley,Idle – Part Number: 4560EL3001A
Pulley,Idle
★★★★★
★★★★★
(5)
PartSelect #: PS3523032
Manufacturer #: 4560EL3001A
$23.35
  In Stock
Gasket – Part Number: MDS47263101
Gasket
★★★★★
★★★★★
(3)
PartSelect #: PS3535212
Manufacturer #: MDS47263101
This door seal is a genuine replacement part for LG dryers. It is a gray, rubber seal that fits around the the opening of the dryer door. It is responsible for creating an airtight seal when the dryer...
$63.31
  In Stock
Hinge – Part Number: 4774EL2001A
Hinge
★★★★★
★★★★★
(3)
PartSelect #: PS3523444
Manufacturer #: 4774EL2001A
$80.53
  In Stock
Door Strike – Part Number: 4026EL3007A
Door Strike
★★★★★
★★★★★
(1)
PartSelect #: PS3522825
Manufacturer #: 4026EL3007A
$30.75
  In Stock

Questions And Answers for TCD1870QGS

Be the first to ask our experts a question about this model!

Common Symptoms of the TCD1870QGS

[Viewing 3 of 3]
Noisy
Fixed by
these parts
Fixing
Show All
Door won’t close
Fixed by
these parts
Fixing Fixing
Show All
Not Heating
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer making a thumping and squealing noise when running
Had to replace front drum support rollers. Removed screws underneath top in back that held bracket that keeps top in place. Slid top towards rear and lifted up. Removed 4 screws that hold plastic front panel in place (inside..2 on each corner) Unplugged front panel electric plugs to remove panel. Opened door..removed 2 screws at bottom of door opening. Removed screws on top of front panel. Unplugged door switch plug. Removed front panel. Removed right front roller with 9/16th wrench for nut. Adjustable for back of stud. Lifted up on drum to get roller out. Reversed to install. Left roller a bit harder to get to stud. Removed and installed same as right side. Did not attempt to replace rear rollers. Have them if needed but very much more involved to replace.
Parts Used:
4 PACK ROLLER ASSEMBLY
  • Mark from WAVERLY, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Wrench (Adjustable), Wrench set
92 of 117 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Screeching during operation
Found disassembly video and watched several times. Suspected that one of the drum wheels had seized up. Found extreme volume of lint and hair inside unit as well as a dryer sheet melted on top of heating unit. Front left drum wheel was worn down from lint and hair jamming its movement. Video made it easy, not a really complicated piece of machinery. Replaced all 4 wheels due to normal wear on other three. Wanted to be sure drum evenly balanced on all 4. Parts came quickly and were easy to install. My sister and I did this together. Would not recommend doing it alone. Took time to vac and wipe down entire unit. Now it runs so quiet we have to look to see if it is operating. Got a brand new machine out of it, saved a couple of hundred dollars in repair bills, and found 11 cents inside the machine. For your own piece of mind, if you have had your dryer for several years, you need to open it up and clean it out. Its not hard... added note, we are both in our 60's... so if we can do it so can you.... Such a feeling of accomplishment, can't buy that in a store....
Parts Used:
4 PACK ROLLER ASSEMBLY
  • CAROL from NAMPA, ID
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Pliers, Screw drivers
41 of 59 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Very noisy when running
We bought 2 roller wheels to replace the ones up front that turn the drum. We watched a video prior to ordering the parts, then followed along with it as we did the repair. It was really easy to complete, with the hardest part being getting some of the screws to loosen at first. Now it purrs like a kitten. We are so happy to have silences the racket. One wheel was completely worn away, with shreds of rubber sitting inside the cabinet.
Parts Used:
4 PACK ROLLER ASSEMBLY
  • CAROLYN from LEBANON, TN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Socket set
15 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!