SGR341AS1 Westinghouse Dryer - Instructions

Raised the lid, removed 2 little screws,slipped the front panel off, disconnected the safety switch, vacuumed everything, slipped on the drive belt and reversed my way out. It was way more easy than filling a grease gun!

Remove drum, replace belt, return drum

I followed the vidio from yor web site it was great without it i would still be trying to get done.

Took the coils off and put the new one on thats all

Installed just like the video described and it went quite well. The part arrived in a short amount of time and the belt was exactly what I needed.Thank you I will visit your web site again. A very satisfied customer. :) Veronica G.

Had the macnine apart before ordering the Bearing Assembly. Reading other comments convinced me to order the Bearing Assembly. Parts were shipped very quickly after ordering and following the instructions on the web site things went back together easily.

followed the video instructions....easy as pie. Glad i bought the belt too....the belt on my dryer was very worn. Changed the bearing with the kit. Very easy to do. The whole job was done in an hour and a half....back together and running without the squeak. Glad i repaired instead of buying a new dryer. Next time i have a problem with an appliance, i will be checking PartSelect first.

Replaced rear bearing on back of dryer. Repair cost $20.00 an a little time. Much better then buying a new dryer. It was easy to repair the video instructions were great. I would do it again it needed.

Just slid it on and took 2 minutes. Fit perfectly. I thought item was expensive throughout searching on the internet for a replacement dial but no local stores had it in stock and they would have to order and it was for the same price as I got it. Decided to order it myself so it would be shipped to my home. Very satisfied with product.

Found instructions on "UTube"some of the screws were in a different position but you can see them. While you have the dryer apart it's a great time to clean it and also as long as you've gone this far replace the belt,it's probably time.

The new latch easily snapped it into place.

My order confirmation email had a "how to" video for installing the parts I ordered. I just watched the video, and the installation was ridiculously easy! We've put up with the obnoxious screeching noise for probably about two years, and with about $40 in parts and less than an hour of work time, we have practically a new dryer!!

took front panel off, removed access panel in rear to disconnect the belt from motor. removed top panel (this is a stack unit) take plastic rivets loose from lint trap, remove lint trap tube, pull drum out after slightly pulling up to dislodge drum from bearing cradle, Remove bracket and bearing from back of unit, clean parts of old grease (be carefull not to loose small ball bearing on back) Reassemble parts using moderate amount of new grease, put parts back together in reverse order.

This is a front load dryer. First unbolt top cover of dryer. Then unbolt screws and connections to control panel. Next unbolt all screws holding dryer door and front bottom panel. Next take belt off of drum and slide out drum from the front. From inside of drum remove 3 screws and remove bearing then put new bearing on and bolt up the same way you take old one off. Using an 8mm socket or wrench remove plastic bearing cage located at rear of dryer. When unbolting there is a retaining clip and small steel ball to be removed from back of dryer. Replace this the same way you take it off. He sure to grease the bearing cage then replace everything back from putting the drum in first to your last step bolting on top cover of dryer. Hope this helps anyone doing this repair.

I have used this company twice now and both times have been a good experience. Would highly recommend!