Models > PPB250E

PPB250E (Type 3) Poulan Trimmer - Overview

Sections of the PPB250E

[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Fuel Line – Part Number: 530069247
Fuel Line
★★★★★
★★★★★
(4)
PartSelect #: PS9472280
Manufacturer #: 530069247
This is the replacement fuel line 25 Inch for several OPE products that use small engines. The fuel line carries fuel from the tank to the carburetor. Over time, the fuel line can become badly clogged...
$4.63
  In Stock
Engine Fuel Filter – Part Number: 530095646
Engine Fuel Filter
★★★★★
★★★★★
(2)
PartSelect #: PS9285148
Manufacturer #: 530095646
This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel...
$3.47
  In Stock
Tank Purge Line – Part Number: 530069216
Tank Purge Line
★★★★★
★★★★★
(2)
PartSelect #: PS9472264
Manufacturer #: 530069216
This part is the replacement tank/purge line for your outdoor power equipment. It is made of clear plastic and is sold individually. The tank/purge line returns excess fuel from the carburetor to the ...
$4.63
  In Stock
Bulb-Purge "snap-in" – Part Number: 530047721
Bulb-Purge "snap-in"
PartSelect #: PS9471212
Manufacturer #: 530047721
$4.63
  In Stock
Spark Plug (RCJ6Y) – Part Number: 952030249
Spark Plug (RCJ6Y)
PartSelect #: PS9484195
Manufacturer #: 952030249
The manufacturer-certified white and silver Spark Plug RCJ6Y ignites the air-fuel mixture inside the combustion chamber of your engine. Consult your manual or check your model number to determine if t...   No Longer Available
Screw – Part Number: 530015814
Screw
PartSelect #: PS9469128
Manufacturer #: 530015814
$3.47
  In Stock
Spring-Starter – Part Number: 545008014
Spring-Starter
PartSelect #: PS9482323
Manufacturer #: 545008014
$5.79
  In Stock
Screw – Part Number: 530015805
Screw
PartSelect #: PS9434260
Manufacturer #: 530015805
$3.47
  In Stock
Screw – Part Number: 530016386
Screw
PartSelect #: PS9469339
Manufacturer #: 530016386
$8.11
  In Stock
Assembly-Fuel cap – Part Number: 578931605
Assembly-Fuel cap
★★★★★
★★★★★
(1)
PartSelect #: PS11811507
Manufacturer #: 578931605
$6.95
  On Order

Questions And Answers for PPB250E

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the PPB250E

[Viewing 2 of 2]
Will Not Start
Fixed by
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Both the Fuel line and the Engine fuel line, where dry rotted.
1) While still attached to the fuel tank, I first sized up the old fuel lines with the newer fuel lines.
2) With a pair of needle nose players, I then removed the old dry rotted fuel ?? lines, from the fuel tank.
3) I cleaned the fuel tank and around the carburetor area, to insure that there was no debris, that could possibly fall into the path of the new fuel lines installation.
4) I then installed the smaller one of the fuel lines, so that it would be out of the way, of the larger fuel line. I Pulled the fuel line through the smaller hole in the fuel tank, with needle nose players. I pulled the smaller fuel line out through the fuel tank filler hole, attached the fuel filter to the smaller fuel line. I Made sure that the fuel filter was extended to the furthest end of the fuel tank bottom. Six inches in all. I then attached the smaller fuel line to the carburetor.
5) I Installed the larger fuel line, followed the same procedures as the smaller fuel line.
6) Both fuel lines where cut on an angle for easy installation. No lubricant was necessary.
7) I filled up the fuel tank with fresh fuel and oil, new air filter and spark plug. It started on the first pull. Amazing.
Parts Used:
Fuel Line Tank Purge Line Engine Fuel Filter
  • Victor from SCOTTSVILLE, KY
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Socket set
6 of 6 people found this instruction helpful.
Fuel and Purge lines had disintegrated
Disassembled it and cleaned fuel tank. Cut and ran new fuel lines, installed filter and reassembled. Parts fit perfectly and got running after not running for over 20 years.
Parts Used:
Fuel Line Tank Purge Line Engine Fuel Filter
  • Casper from ERATH, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
3 of 4 people found this instruction helpful.