PLRU1778ES0 Frigidaire Refrigerator - Instructions

Took out of the box hooked it on in about 5 seconds too easy

I can't believe how fast it shipped!!! Thanks! Great job!

ordered new shelf and snapped in on the side. Problem fixed. Easy

I first noticed my ice cream getting soft. Then 2 days later the alarm went. I emptied the freezer, opened the panels and saw no frost. I saw that 99% of issues were resolved with a defrost timer and thermostat so I ordered those. I have to say the parts came quickly and they went in very easy. My freezer seems to be in the 1% category though. It's still not cooling even though I can measure the temperature at the front of the evaporator coil is cold but by the end of the coil it's almost room temperature. I think a repairman is called for.

New shelf was here in a couple of days, I was shocked it was so quick. Popped it right in! 5 minutes. This is a great website!!!

I did it just like the video it was that easy! love this web site amazing!

I am replacing rhe electrical parts that were wet. The motor and freon piping are sealed and uneffected by the flood.

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

Initially, I traced the noise down to the evaporator motor area. I thought it was the fan blade so I ordered and changed it. Noise level better but still not good. Then I ivestigated problem area again. Removed the motor,discoverd that the motor shaft was loose /drifting which caused the "hummm" and uneven fan blade rotation. Orderd and installed new motor and all is good.

It was simply a matter of snapping in the replacement shelf.

Used needle nose pleirs to slide the old fan off.Then slide the new fan on the spindle.The video really made this easy!

I read the model number on the inside of refrigerator label, ordered the part online from PartSelect. Part arrived in 24 hours. My daughter placed bracket onto fitting and repair was complete in less than 10 seconds.

I ordered the replacement part on-line. When I received the part, I realized it was the wrong part. I contacted PartSelect and worked with the service representative, Julie H. She was excellent!! She determined that I had used an incorrect model number, and then she directed me to where I could find the correct number. She gave me clear directions on how to return the incorrect piece, and then sent me a UPS label to cover the shipping costs. Julie H was at all times, professional, friendly and very helpful!! Regards, Barry Halper

Remove the cover panel inside the freezer, remove and replace the fan motor (pull fan blades off old motor and push on the new one) and replace the cover.

Wasn't hard after I got the right part. Both left and right are decribed on order page as 42 and of course I order the (right)wrong side. Had to reorder (left)and got the correct side. Since the left side disintergated, I decided to keep the right side and replace both sides. Replacing was pretty much a breeze. Recently had to order a door shelf also. Replaced it in less than a minute. Delivery on these parts were great. Here in a matter of two days. Thanks parts replacement guys.