PLD2850RDC2 Frigidaire Dishwasher - Instructions

2 days after ordering the part from partselect I received the part. It took me about 5 minutes to install and has worked beautifully ever since. Great service, super easy installation. Would recommend to anyone.

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

I removed the existing spray arm ring with my fingers (looking at the new part, I could see that it simply screwed into the tub)and screwed the new part in finger-tight. That was all it took!

pull out the old gasket, the right side has a notch to fit the new one. insert until gasket won't go farther.

Big Spoons too high in washer bottom broke off wand. You can simply refit the same part back together if you try. I thought I needed a new one but I didn't. Very ingenious. I will save the one I ordered just in case

The new part replaced three pieces that had disassembled. I simply unscrewed the remaining piece and screwed in the new assembly which fit and worked perfectly. It took less than 10 minutes to repair. During the order process this company asked enough questions to insure that the correct part for that machine was ordered. I will order again, no doubt, when needed. The part arrived on time and as described...............Thanks Whit Smith

So simple a caveman could do it....

The repair only took a few minutes. The hardest part was, after removing the part that was still attached, reaching and getting the threads to mesh so it could be screwed on. Maybe because the unit was full, my access was limited, so the extra 15 minutes were operator error.

unscrewed old one and screwed in the new .

I took the upper rack out and sent it aside and then on the top I just screwed the new one on by my hand and tighten the upper spray arm until it was snugged.

took out screws around door, took off hinges, slip new seal in put hinges back on screws around door. does not leak

My Son used needle nose pliers to remover the old gasket, then starting on the lower right side, inserted the new gasket and used the rounded end of handle of a wooden spoon and pressed the gaste in place by running the handle up and around the top then down the left side. Used sissors to cut the new gasket to length. Door fit very tight. Ran a normal wash cycle and no leaks.

Unscrewed the collar that used to hold the spray arm in place and then screwed on the new one. Very simple. I'm glad that I was able to get the parts without incurring a service visit and significant markup.

replaced sprayarm & found dtc uo ,had to pull washer out & found wires going to vent wrapped up in door spring.removed wires & found that it had pulled plug off vent asm.[which caused it to get too hot to begin with]. plugged back in & ck. operation ok.done

just threaded-it on.