Models
>
PE550
PE550 ((Type2)(530087525)(2008-06)) Husqvarna Trimmer - Overview
Sections of the PE550
[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
Engine Fuel Filter
PartSelect #: PS9285148
Manufacturer #: 530095646
This fuel filter is for lawn and garden equipment engines.
Fuel filter cleans the fuel before it reaches the carburetor.
Work in a well-ventilated area when installing this part. Drain the fuel...
$4.99
In Stock
Questions And Answers for PE550
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the PE550
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Broken teeth on both large and small gears
Remove the gear assembly by removing the three Torx screws holding it to the main body, remove gas tank from assembly and set aside without removing gas lines. Remove cover, with blade still installed, that gains access to the gears, remove the large gear and wash out the grease with gasoline. Put penetrating oil like PB Blaster or Liquid
... Read more
Wrench on the end of the bolt at the bottom of the bowel-shaped clutch bell and let it work in. Then, take an Allen wrench that fits the bolt in the small gear and clamp it in a vise with the short end pointing straight up. Set the recess of the bolt on the Allen wrench. This will put the bowl-shaped clutch bell that has 4 holes in it up. Take 2 #2 Phillip's screwdrivers and put them in one of the holes directly across from each other so they form an "X" with the right screwdriver closest to you and the left screwdriver behind the right one.. Then, pushing the screwdriver in the right hand and pulling the screwdriver in the left hand will remove the clutch bell in a counter-clockwise motion. Reverse the above when installing a new gear.
Read less
Parts Used:
-
Paul from FLORISSANT, MO
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!