MFI2067AES Maytag Refrigerator - Instructions

Pretty much as described in the video except the drawer slides are held in place with phillips head screws not quarter inch nuts.

I pulled the frige out, took off the cover from the bottom with a nut driver. Took off the safety clip then pulled the plug out from the relay then the relay came out. Replaced the part and reinstalled the same way. This was really easy and fast.

simply repalced

I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.

I first change the board behind the touch pad on front of ref. That controls switching from ice to water and temps. Problem ended up being the actual touch screen itself. Part select was great helping with parts and return first part and shipped touch screen out asap.

Followed the video, 5 minutes later new piece installed. Unfortunately, the new plastic is like the old and the same defect could easily recur. thanks

Went on the internet to find someone else with the same problem. I have over 30 Years of Heavy Industrial Air Cond and Refrigeration experience. The troubleshooting was no problem to find the the Control Board failure. Just didn't want to spend $300.00 on the control board on a 3 yr old Stainless Steel side be side Refrigerator. Then we had to wait 6 days for the darn part to arrive. The real difficulty was finding out we had to reprogram the new control board. No directions to reprogram main Control Board came with the part. Also we could not find the original owners manual. (Put up so we could find it later--Right). Had to go to the internet and Google to find the instructions to program the new Control Board. With the CODE #. What a mess.... But we now have cold Ice Cream and Momma is happy.

Take filter out of the box and open the refrigerator. Open the housing in the frig that holds the filter and twist the light-blue piece 1/4 turn, counter-clockwise. (Put the light-blue piece in a safe place.) Take foil away from filter. With 1/4 turn in the clockwise direction, twist the filter into its position. Let five gallons run through the system to get fresh, filtered water.

unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.

Opened the refrigerator door, pulled down the filter cover, twisted the old one out and removed it. Placed the new one in - twisted it into place, replaced the cover and closed the door. It is working great!!

I watched your "silent video". I am a 62 year old woman that is very hands on when it comes to tools and power tools. It was very easy.

After watching the Video on how to replace part, I got to work.. Was a piece of cake to do. Just a few screws and the job was done. I figure that I saved about $125 by doing this easy job myself.

I replaced the broken part. There was one bolt to loosen with a nut driver. I disconnected the original wiring harness, reattached the new harness and reinstalled the hinges, which simply slide into place. Then I reinstalled the small bolt I had removed with the nut driver. The job was with no problems.

Found "pegs" either side of drawer found "holes on side of lid pushed holes on side of lid onto pegs.

I simply snapped it into place, removing the protective covering during the process. Although the cost of the part was higher than expected for a simple piece of clear molded plastic, the whole job took about two minutes total. And, moreover, the part arrived two days earlier than I anticipated.