MER6755AAB Maytag Range - Instructions

My husband removed the screws and pulled out the wires as far as he could. The hardest part was that he had a hard time getting to the back of the oven so I had to take over for him. I pulled out the wires so that I could see the connections and with a needle nose plier held the external part of the connection and pulled out the internal part with my fingers. Once the old element was disconnected on both sides, I put in the new element and pushed in the new connections. I pushed the 2 wires into the back of the oven, put the 2 screws in and - DONE. I think this was the easiest repair we have ever done. We always run into a problem - but not this time. I have to say that I did read some of the other descriptions that were written and they were very helpful.

1. Turned off power at breaker, 2. removed two screws holding cooktop (located at top of oven in door seal area), 3. removed 4 set screws holding burner in place, 4. Removed wired (blade connections) one at a time and moved to new burner, 5. installed set screws to hold burner in place, 6. lowered cooktop and reattached screws to hold in place, 7. turned breaker back on.

After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.

Remove the element hanger Phillip screws (2) in the top center of oven. Then remove the Phillip screw (1) each from the connector plate at the rear of the oven. Slide the electrical connector off of each end of the old element and remove it from the hanger. Reverse the above to install. Most important, turn off the circuit breaker for your stove/oven.

I think the installation instructions are fairly self explanatory. This is the second item I've ordered from Parts Select and I'm thrilled with their service. The items are always less expensive than other sites and they deliver what they promise. I would highly recommend them.

i did fine