Models
>
MDE3000AZQ
MDE3000AZQ Maytag Dryer - Overview
Sections of the MDE3000AZQ
[Viewing 1 of 1]Keep searches simple, eg. "belt" or "pump".
Screw, 8/18 x 3/8
PartSelect #: PS11746840
Manufacturer #: WP90767
This screw is sold individually.
$5.42
In Stock
Timer Knob Base
PartSelect #: PS11739297
Manufacturer #: WP22001659
This timer knob is not quite three inches in diameter. It is all gray in color and it is made entirely of plastic. This has a D-Shaped Shaft.
$23.31
In Stock
Screw
PartSelect #: PS11742733
Manufacturer #: WP489128
This screw is sold individually.
$13.17
In Stock
Dryer Timer
PartSelect #: PS11741062
Manufacturer #: WP33001730
This timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
$234.48
In Stock
Questions And Answers for MDE3000AZQ
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The dryer would not cool down in the permenant press cycle or any other cycle.
Pull the electric plug. With a nut driver and phillips screw driver remove two bolts and three screws on the rear access plate. Gently pull the knob from the front pannel and with the nut driver remove the two bolts under the knob. The timer is now loose from the drver. Match the wire plug codes on the old and new timers. Remove one wire
... Read more
at a time from the old timer with pliers and plug it onto the new timer on the same coded pin. Slide the timer back into the pannel and replace the two bolts that hold it. Replace the knob. Replace the three screws and two bolts holding the back pannel. Plug the electric cord back into the wall socket.
Read less
Parts Used:
-
george from camden, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Pliers, Screw drivers
14 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Heater Stop Working!
Checked all other electrical and mechanical operations and all seemed operational. Removed heating element from unit and checked with vom. It was ok. Reinstalled and began checking wiring with vom per the diagram in the control panel cover. Determined that the contacts for the heater in the timer unit had failed. (Open) temporar
... Read more
ily shorted these points on the timer with a strap to make the dryer work. Wife is now happy. Two days later when the timer part arrived, installed and now all is operational. Good for another 10 years. Dick
Read less
Parts Used:
-
Richard from Long Valley, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers
4 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Intermittent operation.
Removed the old timer and installed the new one. Easy to install with a screwdriver and common sense.........
Parts Used:
-
David from MERIDIAN, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!