Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Herman
February 13, 2018
Do you have any pictures that show the clip spring installed?
Hello Herman. That is a good question but unfortunately, we do not currently have installation instructions for this particular part. I was able to find some installation help from other customers that might help. They have reported: "There are 2 slits in the front part of the unit that one side of the clip will go into and hook into place. The other end will just hang inside the unit. You will probably have to disassemble the unit to install the part. I hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Steve
February 18, 2018
I'm looking to buy extra plastic clips that hold the outside plastic panels to the front part dryer. The plastic panels are just to the upper left and right of the door, and they are just under the control panel. These clips are like a spring type, and break rather easily when they are pulled out or pushed back in again.
For model number GGW9250PW3
Hi Steve,
Thank you for your question. The part number listed under your model number for the retaining clip is PS11741468. I hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
Fred
August 30, 2023
The Lint Filter Trap Spring Clip detached. Can you use the Filter without the Spring Clip? Otherwise, I am looking for help to reattach, such as manual reference, video, or other instructions.
For model number WED9150WW0
Hi Fred, thank you for contacting us. You may need to reattach the clip spring because it attaches inside the lint duct and prevents small items of clothing from contacting the blower wheel. In order to reattach the clip spring, you just need to un-thread the screws of the front panel present at the front bottom of the dryer. After removing the panel, you will have the excess of the lint duct. In the middle of the lint duct, a small groove is present in which you may simply slide the clip spring in such a way that it goes under the lint filter. You may also remove the lint filter and place it back after attaching the clip spring. A small edge of the clip will remain outside. Make sure the clip is not falling outside, it means you have installed it correctly. Good luck with this repair!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
