MDB9150AWB Maytag Dishwasher - Instructions

Ordered a plastic part from supplier and installed the part, door works fine now.

with ease

Removed lower dish basket, removed the two original peg clips,then snapped in the two new peg clips and adjustable prong assembly worked as required. No further problems experienced. Appreciated the rapid receipt of parts. Will definitely remember this web site for future appliance parts.

I used video instructions from site, and the repair went smoothly

Disassembled spray arm the way the website describes. Found an amazing accumulation of scale and soap scum. Everything was seriously gunked up. Cleaning and rodding out the spray arms and pump housing screens takes a minute. Be careful not to break or puncture the screens. Dont try slapping the pump housing filter on the driveway. Its brittle and will break. Suggest buying a new one anyway. Its nearly impossible to clean. Simply clean it all up and re-assemble. Oh and bask in the praise from your wife.

After viewing usless videos, I finally read other comments and discovered how easy it was to just twist the sprayer.

Changed float switch to no avail! Ladeled out the water. Disassembled the entire pump unit inside down to the motor shaft and checked all pieces for trouble. Could find nothing wrong. Now trying to determine if the problem is in the timer or motor.

Easiest ever. Recycled the old one and put the new in its place. We are trying to place the silverware in, rather than dropping it in. It was suggested in the video from this website.

Watched video, very helpful. Pulled dishwasher out a foot from counter, which was the most difficult part due to tight fit, carpet, and copper tube water connection. Once the washer was out it was easy to replace the linkage and while it was out did both sides.

I pulled out the dishwasher. Saw that a plastic part linking the door and spring was broken.I was able to ID the part easily on PartSelect. The part came quickly and was installed within 30 minutes. Dishwasher feels like new.

Found picture of the "stack" of pieces online. Decided to give it a try and started disassembling the parts. When looking for replacement parts, found the video @ PartSelect. Wish I had seen it before, but it confirmed I did everything right. It was refreshing to see a step by step instructional video, made everything look easy and it was! Replaced the part and followed the suggestions of the video about replacing the gasket as well and what parts to clean while working. Great help. Very pleaased with the speed of the whole process. Ordered the piece on Sunday, had it on my doorsteps on Tuesday!

The dishwasher would hang up after about 10-15 min. on auto wash. You could hear the control board click but the pump wouldn't start. Ran the diag. process and it came up turbitity sensor. Found one on e-bay (no longer available from parts houses)put it in and had the same problem, this time the error was low motor voltage. Found, from others talking about the same problem on the net, that there were two other things to look for. One is where the wires go out the bottom of the door. The way the machine is designed after time the door will start to cut through them. Taped up any cut wires and made sure the connection was still good. Second, check the back of the control board for cold or loose solder joints. I found two for sure that were cold and the pigtail was also loose. Re-soldered the connections and ran a full cycle with no problems. The solder connections were most likely the problem to begin with. Hope this helps.

Tray outside of dishwasher----Just opened bags and carefully pressed on --- be careful with metal slide stops

Took out the screws that held the inside panel on. Replaced the broken latch with the new one and put the screws back in. The lady that took my order was really on the ball and sent me the correct part. I'll do business with you whenever I need any parts.

I slid the dishwasher out about a foot and easly replaced the Door Spring Linkage. I took more time to remove and replace the screws than it did to replace the Door Spring Linkage. Very easy repair that anyone can do.