Models
>
LDS5811ST
LDS5811ST ((ASTEEUS)) LG Dishwasher - Overview
Sections of the LDS5811ST
[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
Connector Assembly
PartSelect #: PS3524406
Manufacturer #: 4933DD3001B
This dishwasher door hinge cable assembly connects the door to the spring. The door hinge cable and the door spring apply tension to the door to prevent it from dropping open too quickly. This part co...
$17.46
In Stock
ROLLER ASSEMBLY
PartSelect #: PS12075858
Manufacturer #: 4581DD3003C
The dishwasher roller assembly connects to the dishrack, and is located in the lower level of the dishwasher. It allows the dishrack to easily slide in and out. If the lower rack keeps falling off the...
$9.08
In Stock
Roller with Axle
PartSelect #: PS3523050
Manufacturer #: 4581DD3002A
The rack roller and axle in your dishwasher allows the dish rack to slide in and out effectively.If you notice that your dish rack is not performing this function, or if one or more of your rack rolle...
$11.47
In Stock
MOTOR ASSEMBLY,AC,PUMP
PartSelect #: PS16223509
Manufacturer #: EAU61383518
On a washer, this part is used for circulating the water. On a dishwasher, it is used for draining the water during operation. If you notice your appliance is not draining properly, the circulation pu...
$74.46
In Stock
Door Gasket - Black
PartSelect #: PS3522654
Manufacturer #: 3920DD3005A
This is a door gasket for a dishwasher. It creates a watertight seal between the dishwasher door and tub to prevent leaking while the appliance is in use. The gasket is approximately 76 inches long an...
$47.33
In Stock
Accessory Assembly
PartSelect #: PS3525525
Manufacturer #: 5001DD4001A
This is an accessory assembly, otherwise known as a mounting bracket kit, for a dishwasher. This kit includes two brackets, a hose clamp, and two screws. The brackets are perforated so they can be cut...
No Longer Available
HOSE ASSEMBLY, DRAIN
PartSelect #: PS11732679
Manufacturer #: AEM69493807
Replacement dishwasher drain hose. Per the manufacturer if the drain hose being replaced does not have the vent tube going to the water inlet assembly a new water inlet will be needed.
$38.43
In Stock
Questions And Answers for LDS5811ST
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the LDS5811ST
[Viewing 11 of 11]Leaking
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Will not drain
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dishwasher door became heavy and would fall to the floor if you didn't hold it up.
Removed mounting screws from sides of disher. Removed broken piece of connector assy still attached to hinge. Attached new connector assy to hinge then looped it around pulley with spring attached to opposite end. Need both hands to pull spring up to side of tub and connect it. I would suggest replacing both connector assemblies while you have the dishwasher pulled out. Push dishwasher back in and mount with screws.
Parts Used:
-
Charles from DENNIS, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
25 of 29 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The hinge spring and/or connector assembly were not functioning, so the dishwasher door was extremely heavy.
Replacing the spring and connector assembly (the cord had frayed and broken) was easy and took only a matter of minutes to do. Wrestling the dishwasher in and out of its space under the counter was very difficult. Because my kitchen is compact, I had to move the refrigerator first, then disconnect the Romex cable and water lines from the dishwasher before I could pull it fully from under the counter. The side panels have screws in the front and the back, so the appliance had to be moved out until its back was exposed. But I got the job done and the door works just like a new one now!
Parts Used:
-
David from NEW ORLEANS, LA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers, Wrench (Adjustable)
9 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dispenser wasn't closing
-
Kristyn from Downers Grove, IL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
7 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
