Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LAT9416AAE > Parts

LAT9416AAE Maytag Washer - Parts

All parts for the Maytag Washer LAT9416AAE

Below is a list of all parts for the Maytag Washer LAT9416AAE - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the LAT9416AAE
15-28 of 187
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$19.94

Outer Tub to Pump Hose

This hose connects the outer tub to the pump of your washing machine. It is twelve inches long and all black in color. This hose is made entirely of rubber.

$86.67

Drain Pump

This washing machine drain pump is intended for use with automatic washers that have been manufactured since 1958. The pump itself is made of plastic, though it does come with a metallic belt pulley.

$66.22

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter. It comes with its own anti syphon and wire guide.

$36.26

Lid Switch Assembly

This black lid switch assembly comes complete with a bracket, two switches, and a fuse. An open fuse might indicate that the lid switch is bad. The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

$29.07

Lid Switch Assembly

This kit includes the lid switch and the plunger. The pin on the lid pushes on the lever of the switch to tell the machine that the lid is closed.

$4.63

Spring Retaining Clip

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If you notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.

$69.82

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter. This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on t...

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$81.97

Agitator Auger and Base Assembly

This part does not include the dispenser cup that is found on the top of the upper agitator.

$27.27

Glide and Spring Kit

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

$2.96

Screw

Sold Individually.

$5.65

Screen

Found on the water inlet valve.

$28.73

Water Injector Assembly

The part includes the hose, water injector and clamp.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

All Parts for the LAT9416AAE
15-28 of 187