Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KUDS30IXSS4 > Parts

KUDS30IXSS4 KitchenAid Dishwasher - Parts

All parts for the KitchenAid Dishwasher KUDS30IXSS4

Below is a list of all parts for the KitchenAid Dishwasher KUDS30IXSS4. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KUDS30IXSS4
43-56 of 200
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$50.78

Heating Element

The heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of t...

$47.34

Drain Hose

This part is used to drain water.

$4.88

Retainer

$4.88

Adjuster Housing Cover

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components od the adjuster housing.

$40.58

IMPELLER

$4.88

Seal

$26.00

Middle Spray Arm

The spray arm in your dishwasher spins and sprays the water that is used to clean your dishes. If the spray arm is damaged, your dishwasher will not clean properly, and you will ne...

$49.19

Feed Tube with 3rd Level Spinner

Also known as the water supply tube.

$171.31

Sump and Motor Assembly

This part moves water up from the sump collection area and up through the spray arms.

$32.80

HOSE-FILL

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

$26.63

Adjuster Arm Clip

Sold individually.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$35.78

Manifold

Also known as a water supply tube which is used for your middle spray arm.

$8.43

Tine Row Pivot

All Parts for the KUDS30IXSS4
43-56 of 200