KUDI24SEBL1 KitchenAid Dishwasher - Instructions

Removed the old seal, cleaned the groove, followed directions, placed adhesive per directions, placed new seal in groove per directions, closed door for 24 hours, job was completed. I was concerned that the new seal did not look like the original seal, but the new seal actually was better then the original seal.

Removed rinse arm nut and arm. Replaced the seal, bearing, and retaining nut. reassembled.

I followed the video directions and it worked perfectly. The dishwasher came with the house and I don 't think it ever cleaned as well as it does now.

Kitcheaid's online diagram showed me the parts and numbers I needed - Really helpful. I just ordered the parts and screwed them in, no tools were needed for this particular repair.

With the video and easy instructions, I was able to fix it in less than 15 minutes.

I unscrewed the middle arm assembly that was already attached. Then I simply screwed the new middle arm spray piece that I ordered. It is a very simple fix. The new kit (that is all one piece) is ver easy to install.

Made sure the power and water were not connected to the dishwasher. Removed the bottom panel. Unhooked the old part. Put some plumber's tape around the threads, hooked it all back up. Runs just as good.

Used your video and assembly diagram. Washer works like new now! Had trouble removing the screw from the center of the large black plastic hex nut under the Pump Outlet. Video shows that an adjustable wrench will hold it, but I had to use vise grips. Also needed to use a socket to remove center screw.

Partselect site had pictures of my unit and recommendations as to which parts I needed to correct the problem. The parts came quick, the Partselect videos showed me how to make the repairs and the repairs were quick and easy. Dishwasher seems to be working fine. Thanks,

After watching the repair video I ordered the parts to repair my dishwasher. They arrived quickly and I installed them according to the video. It was so easy and quick. I use the dishwasher about 4 times a week and it is working like a new one. Thanks partselect. You saved me a bundle. H. Cranmer nj

Price of the Kit was better than ordering just the tube from Mfg. Marked old hold downs spots, disassembled, installed hold down then attached spray arm/washer and tube. Two screws to take off but only one screw on install as the hold down had been reenginered. Mark old parts for top or bottom and remember if you turn the rack upside down that will affect the holes on the spray arm.

Excellent service, fast delivery. Recimended...great outfit.

Door does not have to be taken apart. Soft touch cover panel is fastened to door with an adhesive.Just lift old soft panel cover off starting at one corner using a knife...then peel the entire cover off. I used my finger with no solvent to roll the old adhesive into small balls and remove it. After 95-98% of the old adhesive had been removed I wiped the remainder off using a little enamel reducer. Then, starting with the top of the new soft touch cover panel align it with the recess into which it fits and stick it down avoiding air bubbles. Fairly easy installation.

Easy repair. The sprayer arm mount broke. replacing it was a breeze. I found a helpful video on-line. Took about 20 min total.

Job went well only about 10 min to make repair. thanks for the video on repair. I would have ordered one of the seals if I had not watched the video. Thanks Bobbie