KIDS42EPSS0 KitchenAid Dishwasher - Instructions

After reading the manual that a flashing green light is caused by a heater circuit, I assumed that the cause was the heater element. I found PartSelect on the web, ordered the element and received it the following day. I watched the video on installation and replaced it within a half hour. Unfortunately, the clean light still flashed. I went back to PartSelect site, read other peoples comments and ordered a thermistor. The delivery took one day and the replacement less than a half hour. Again, the light flashed. I ordered the high temp thermostat, received it immediately, changed it out and still had the flashing clean light. From the Part Select site, I learned the hi-temp/heated dry combination reset after the wash cycle for the rinse cycle without the heated dry. Dishes come out clean. I'm afraid to order the controller for over $120.00 and have the same outcome. I wish I had invested in an ohm meter. I am very happy with the PartSelect web site. It is very informative, easy to locate the parts and very quick delivery times.

I am a 65 yr old woman and I can tell you that this repair was really easy. Just watch the utube video and there you have it no need to hire an expensive repair person on this one :-}

Turned off the electric. Opened the dishwasher. Removed the silverware tray. Removed the inner panel. Removed the wiring cover. Replaced the fuse and wires.

removed door cover,removed board cover and with needle nose plier remove fuse harness and replace with new one that simple once you determine damage part to replace.

after replacing the front control panel the dishwasher started and almost did a complete wash before for no reason just stopped before completing the cycle.I then ordered the Thermal fuse and the door switch kit. I installed the Thermal fuse and thought I would put everything back together to see if that fixed it. It did, so tomorrow I am returning the door switch kit for a refund.The repair instructions were very good.

i took the inside door off and took the 2 switches out and replaced them; not too difficult.

I watched your video on YouTube and followed instructions about changing fuse very simple. Dishwasher works great now.

The part was exactly like the one in the dishwasher, and the picture that came alongwith the part was perfect.I removed the screws to separate the outer door from the inner part. Removed the plastic cover from the control unit, and recognised the part right away. It was then a simple task for removing the old part and installing the new one. Reassembled the door, and the dishwasher worked perfectly. G.E. Buena Park, CA