KGCT365XBL1 KitchenAid Cooktop - Instructions

Turned off the gas then disconnected the gas line. Unplugged the AC cord and removed the unit from the counter top. Had to locate a suitable area to lay the cooktop, rather large. The bottom cover is held on by 6-8 sheet metal screws, however, the gas regulator and nipple must be removed also for the cover to come off. I removed the Igniter module screws, leaving the wires connected and mounted the new module in it's place. I then removed one wire at a time from the old and put it on the new part. Replaced the back cover and reinstalled the gas regulator with fresh pipe sealant. Probably took an hour including cleaning the top and counter top.

Old knob was shattered, so there was no removal. Opened package and pushed the knob on. Turned to test.

I simply pulled the cracked knob off the stovetop and replaced it with the new knob. Very easy!

A friend visiting turned a knob on my black glass Kitch Aid Cooktop the wrong way. It goes from High to Low and counter clockwise rather than clockwise. Therefore it has happened many times over the 19 years I have had it. I have had to get replacements a couple of times and it has always been a hassle. This time when I was down to the last one I went online, found your website and without having to crawl under my stove to look for a model # I was able to just match it up with the #'s on the back side of the knob! I ordered a few and it was here within 2 days!Wonderful!Thank you!Karen From Katonah

pulled off the old metal clip with a pair of needle nose pliers and pushed the new knob on...voila! Turns out the rest of my knobs are almond and I bought white, but it's okay...knob was pricey but exactly the part I needed.

Bought in auto repair store special black glue used for sealing gaskets. Husband needed to use latex gloves, toothpicks, ice pick, and small screw driver to glue and install new burner pads.

Removed the broken items and replaced.

The repair was fairly straightforward, much easier the second time around. The first part was defective. (irregular spark). I reordered and installed the new one. It works, but nowhere near as good as the original.The problem is that the frequency of the spark on these replacement modules is only once per second. To get technical, the gas as presented to the spark is turbulent, causing several sparks to occur before the ideal mixture coincides with the spark. Needless to say, there is an excess of gas wafting around the kitchen until it lights, sometimes in excess of 20 seconds. NOT SAFE! Our BBQ and fireplace insert spark orders of magnitude faster than this.

Gently pressed the lower two clips onto my thumbs as I pressed the skirt into the cooktop skirt hole. Be gentle or you can break the new skirt!

Good

I pulled the knobs off, lifted the broken skirts out and snapped the new ones in.

popped off the old knob and place on the new. Simple.

Removed cracked know and replaced it with a new knob.

the decorative backings on our stovetop knobs had become frayed, and I simply pried off the old ones,and installed the new ones. I have use Parts Select for years for various parts replacement, their service is quick and accurate. When I need a part, I always check here first.

Pulled off the old and pushed on the new!