KEYE665BWH2 KitchenAid Dryer - Instructions

Taking the back panel off of the dryer , making sure it was unplugged of course. I removed a few screws exposing the element seeing the coil was broken not alowing it to heat. Going online i found Partselect and boy was I glad I did. They shipped the same day I ordered and in a few days the part came to my door.Within 15 minutes the dryer was together and running. Thankyou Partselect I will be back

I had knee replacement 2 weeks before our dryer stopped working! My wife took the rear panel off & replaced the parts under my reading the instructions ! Very easy to replace!

Followed video on part select website which showed exactly how to do the repair using the model I have as an example. The repair went smoothly with no surprises, except for how easy it was.

Used video of PartSelect guy on YouTube to diagnose bad thermal fuse with multimeter. Removed back panel of dryer with nutdriver, removed thermal fuse, found no conductance across terminals. Ordered new part. (It arrived very quickly!) Put in new thermal fuse, replaced back panel. Shortened flexible vent tube so there would be fewer bends. Dryer works now.

I unhooked the gas line, removed the vent hose and then removed the back of the dryer.I replaced the thermal fuse and the cycling thermostat in about 5 minutes. Most of my time was spent vacuuming dust in and around the dryer. The job was easy and my 14 year old dryer works like new.

Having read the instructions and watched the tape, I pried out the remaining catch with a flat screwdriver, read about what the color scheme on the parts wasbout and pushed in the correct part. Voila ! Done in probably two minutes.(By an 82 year old woman!)

The dryer belt was delivered promply, afterwards I lifted the top of the dryer and unscrewed the front panel, so it would lower. Then I watch a 5 minute video and it clearly demonstrated how to install the belt. This was my first time, so it took about 30 minutes.

after replacing my heating element, my dryer still wasn't heating. So i replaced the thermal cut-off unit. from ease of finding the part, to ordering and the instructional videos...this was a no-brainer.thanx guys!!

It could not have been easier, thanks to the video displayed when I ordered the part. It was as easy as removing the back of the dryer, taking out the old fuse and putting in a new old. I have NO repair experience, so little I had to borrow the nutdriver from the maintance man at work. I was more then a little leary to try this repair on my own, but decided it was worth all the money I would save not having to call a repair man for my dryer. Sure glad I did I will continue to attempt more repairs on my own.

i replaced the two sensors in the heating element which were very clear in your diagram and it worked perfectly

Checked voltage coming into unit, good. Checked schematic and traced the voltage through the safeties and interlocks. Found the problem at the thermal link. Isolated unit from all voltage sources. Removed part and ohmed the resistance. Found it open. Ordered new link and it arrived before schedule. Replaced and connected wiring, returned power and tested. Worked great! Very easy to find and repair!

PartSelect sent the exact right part, and very quickly! YouTube showed me how to install it. The only hard part was the bulkiness of the drum, which is why I marked "a bit difficult" for the repair.

Got online with parts select, easily found the parts needed and ordered them. They arrived very quickly. The repair itself took all of 5 minutes and now the dryer door stays shut like it is supposed to. Only complaint is shipping was more than the parts but then again, I didn't waste a lot of time running all over town looking for what I needed. So, in the long run I saved money , especially when compared to a calling someone else to fix it.(big bucks for even the most minor service call as you all know).

Did all according to the online demonstration and everything was as easy as 1-2-3. The dryer works like new again.

pop off put in done