JGD8345ADB Jenn-Air Cooktop - Overview
Models starting with JGD8345ADB
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Range Grease Filter
PartSelect #: PS11743846
Manufacturer #: WP707929
The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is rou...
$25.87
In Stock
Top Burner Igniter
PartSelect #: PS2082000
Manufacturer #: 74004053
This is a surface burner igniter, also known as a top burner ignitor and stove top spark electrode. It is used to generate the spark that lights the surface burner. If your stove will not start, eleme...
$27.11
In Stock
Refrigerator Screw
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$20.53
In Stock
Dryer Screw
PartSelect #: PS11746840
Manufacturer #: WP90767
This screw is sold individually.
$7.71
In Stock
Burner Head
PartSelect #: PS11741675
Manufacturer #: WP3403M075-10
This surface burner head is for ranges.
Surface burner head distributes the gas through holes or slots to create an even flame across the cooking area.
Shut off the gas supply and unplug the ran...
$125.52
In Stock
Range Knob
PartSelect #: PS11744699
Manufacturer #: WP7733P314-60
Sold individually. This knob accepts a D-shaped shaft.
$9.85
In Stock
Range Fan Switch
PartSelect #: PS3408226
Manufacturer #: W10341820
This may look different than the original, but is a functional equivalent. When installing this part, you may be required to drill holes and file the metal edges to adapt the switch to the original panel.
$171.96
On Order
Spark Igniter Set
PartSelect #: PS11744110
Manufacturer #: WP74005890
This part provides the spark to the burners.
$55.24
In Stock
Range Glass Grease Collecting Jar
PartSelect #: PS11757591
Manufacturer #: WPY707869
This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.
$47.95
Special Order
Grill Grate
PartSelect #: PS2078365
Manufacturer #: 71003267
This grill grate is sold individually.
No Longer Available
Brass Seal
PartSelect #: PS11744111
Manufacturer #: WP74005893
This is the replacement brass seal for your range or cooktop. It is made of brass and is approximately 1 inch in diameter. This part may also be known as the surface burner orifice holder seal. It pre...
$7.87
In Stock
Spark Module - Oven
PartSelect #: PS2094592
Manufacturer #: 8215557
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
$83.37
In Stock
Common Symptoms of models starting with JGD8345ADB
[Viewing 5 of 5]Will Not Start
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Gas smell
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
replaced filter
-
ELOISE from MILFORD, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
482 of 509 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old grease filter that I actually did not know I had to change
Removed the old grease screen and cleaned the entire area thoroughly and replaced the screen
Parts Used:
-
deborah from fort pierce, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
449 of 537 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
gas burner ignitor failure
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed t
... Read more
hat rust and dirt had built up around burner to pan connection.I used my oil filter wrench to turn slightly the burner to remove it from the pan to clean.Reassembled in reverse order.
Read less
Parts Used:
-
roy from East Providence, RI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
141 of 161 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!