JDB3610AWX Jenn-Air Dishwasher - Instructions

the repair was so easy. I called my local maytag repair man and they want 85.00 dollars for the call and 6.00 a piece for the parts. well really. so i thought how hard could it be? I ordered the parts from Part select and fixed it myself. it took a whopping 5 minutes, 1) un snap the clips at the end of the sliding metal bars and slide out the top rack and remove it.2) take old parts off slide bars by unsnapping them and pulling them off replace them with the snapped together new parts each part has 2 pieces and they will slide one in the designated place there are 2 on each side3) Replace the upper rack swing the clips to secure the rack and then replace the plastic pieces at the ends of the metal bars. Saved 88.00 bucks took me 5 minutes .

We discovered water leaking from the underside of the dishwasher. A closer inspection revealed that a pinhole had opened up in the rubber coupling at the bottom of the top shower pump hose. This piece is permanently attached to the pump hose, so you have to replace the whole thing. Repairing the dishwasher was an easy and straightforward affair as many other reviewers have described. The biggest difference between my experience and others was the presence of a cloth-like covering over the entire tub of the dishwasher. I assume this was either a thermal or sound insulation of some kind. To access the shower pump hose, it was necessary to remove the covering just enough to reach everything. The cover was held in place by some flexible black plastic pins. All that was needed was to work these back and forth until they slipped out of the underlying metal structure. Once I had the insulation pulled back it was a few quick minutes and the dishwasher was up and running.

Our dishwasher has two gaskets, one around the top and one on the bottom. We ordered these two pieces with the help of staff at PartSelect who were very helpful and savvy. The gasket around the top part was very easy, had to be pulled out and replaced with the new one. We made sure the gasket went in exactly as we pulled it out with the thicker side inside the groove. We had to struggle with the bottom gasket that was stuck due to lots of hard water deposits. We cleaned first with lime-remover and then pulled out the rubber gasket from the bottom and pushed in the new one in the same direction. We had to do this twice before we got it situated. Then we loaded the dishwasher with cleaner and ran the cycle. No more water leaking out the sides.! Success!

It was a walk in the park with the how to videos on how to install this little part.... That made it very easy and simple... That was the part that helped the most... Thanks...This is a great place to buy repair parts....

removed old rack and inserted new one - it slid right in - no tools needed - The most remarkable thing about this whole process was the speed with which we received the replacement part. I ordered it in the late afternoon on a Friday, and it was delivered the next morning. Great service!

I removed the inner plastic panel from the dishwasher door, and disconnected the two solenoid motors from the soap dispenser assembly. This made it possible to work on the door panel at a table. I disassembled the soap dispenser mechanism and scrubbed everything with a stiff nylon brush and then rinsed it off. I then rebuilt the dispenser mechanism using the new soap door latch and gasket and reinstalled the panel (after scrubbing all soap deposits from the area around the dishwasher door).

It helped that I have some mechanical abilities because instructions were not very clear. The iso drawing was very helpful and help me out alot. Put it back together and works great. Thank you.

Appliance is at least 14 years old. All we had to do was put rollers on and place it in the dishwasher! The other great thing about PartSelect is that it ships same day...we had the part two days later. We will order from you again if any parts are needed! Thanks.

removed old gasket which is a friction fit only. Pried gasket out at bottom on right side and pulled whole gasket out. that took 15 seconds. Looked at old gasket to see how it fit into slot. Pushed new gasket into slot. This took about 2 minutes. job completed. no leaks.Really really easy.

After replacing the door foam strip and the soap dish grommet I still had the water leakage at the bottom of the door, in fact a bit more leakage. Then I replaced the foam insulator strip on the inner door. Still had the leakage! I opened the door after the water finished the fill cycle and noticed the water level was unusually high. Apparently the water float was partially stuck allowing an over fill. I pushed on the float downward a few times and removed some of the water and re-ran the washer. The leak was reduced to a few drops. Removed the float and soaked it in vinegar to clean it and this cured the problem.

simply placed the new float assembly where it needed to go. problem solved!

After reading other repair stories, I ordered the big 3, door gasket, grommet and inner door foam insulation strip. For $80 I wasn't going to do the trial and error method. Parts were here in 1 day, and after doing a trial run prior to receiving the parts, new parts were installed in 20 minutes. Don't know which one was the problem, but no more leak. Happy wife, happy life.

I watched the " How to video " that was supplied on your web-site. It was very easy to do and simple to understand. My wife say's I'm her hero because I saved us a $150.00 service call, + the cost of the gasket, which would have cost more if they furnished it. Thanks----

Removed inner door panel , remove latch assy, installed new latch and wax motor , screwed panel back in place ! done!! Less than 10 mins

I went online and found PartSelect, put in my model number (thinking no way would anyone one have the right part because the dishwasher was so old). PartSelect came up with the rack, I ordered it, still having doubts. It arrived in a matter of days and it fit. I had a problem with the water tower. I couldn't take it off the old rack. PartSelect had a customer online with the same problem with the tower. I followed his instructions, it came off the old rack and onto the new rack so easily. I'm a very old grandmother, and I did the whole process all by myself. That was a wonderful experience and my old dishwasher is like a new dishwasher. Thank you all so much.