HDA2000G02WW Hotpoint Dishwasher - Instructions

I removed the old corner tub baffle's and replaced them with the new one's and that took care of the problem. I used a putty knife to remove the old one's and put some new adhesive on and put the new ones in place and let them set up for two days to let them really set up and they work really good no leaks.

I removed the sump cover and it was disgusting! This was the first thing I did to trouble shoot. I tried cleaning the cover but it was just too dirty. I ordered a new part and now I don't have any more water pooling at the bottom. I unscrewed the cover and then screwed on the new one. It did not come with screws so keep your original screws.

Remove front shields on bottom of dishwasher. Shut off dishwasher and electricity. Unplug electric connection. Unscrew brace holder screws on front. Remove clamped on hose at back of valve. Unscrew valve from copper water pipe. Screw on new valve to copper water pipe. Put on clamped hose. Screw on bracket. Plug in electric connection.

Put rack in place and snapped new one in.

Quick and easy...a 7 yr old could have done it.

We removed old gasket, cleaned surfaces and installed new gasket.

I removed the plastic inner door liner, removed the timer assembly. Replaced both plastic parts, Detergent cup release arm and dispenser release timer lever. The most difficult part was reassembling the timer lever spring. Long nose pliers made it simple. Works like new.

Turn off the power at the breaker panel. Turn off the water supply that goes to the dishwasher. Remove the front lower panel to gain access to disconnect the water line and electric. Now remove the two screws that connect the dishwasher to the countertop. You should be free to slide the dishwasher from under the countertop far enough to remove the drain hose. Slide the dishwasher out all the way and lay on the floor door down. Loosen the two clamps that hold the motor up. Remove the motor bracket, (should only be one screw. Disconnect the wires from the motor. Now just pull the motor down and out. Repeat the process to install the new motor. I took several pictures before I started removing anything. The instruction that comes with the kit is very good. Their will be parts in the kit that will not be used. Not to worry!

I popped out the stoppers at the end of the gliders. removed broken rollers and slid on new rollers.re-installed stoppers, tested all functions. tested good

Pop out the old baffles with the help of a screwdriver, push in the new parts in their places and done.

I took the slide ends off the slides. Removed the top rack, removed the old worn out rollers. Installed the new rollers. I turned the slides over as the top of the slides weren't as worn as the bottoms. I replaced the slide end caps on the inside of the slides, put the rack back on the slides. Replaced the slide ends on the outside of the slides.

just ordered the parts and sat them in place...I thought at first I would need a new dish washer...wow too easy finding the reason and the parts..thank you so much!! saved hundreds of dollars,ps I am a woman,not mechanically inclined

First I removed the excess water by using my shop-vac both inside the machine as well as near the bottom drain valve. After cleaning out that valve (which somehow had accumulated a pair of underwear) it was apparent that the drainage pump motor was no working (loud hum, not spinning). Replacement was easy, folowing instructions found everywhere on-line. Now the machine is working perfectly again.

got replacement valve from part select and works like new this dish wash er is 24 years old. believe it or not did the job with pair of pliers and screw driver. used pliers to take off clamp and screw driver to take out 2 screws and replaced the valve the same way in reverse

door gasket dried out due to not using the dishwasher very often and needed to be replaced. removed door, replaced gasket, and re-installed door.