GSS22IFRECC General Electric Refrigerator - Overview

Sections of the GSS22IFRECC

[Viewing 8 of 8]
Keep searches simple, eg. "belt" or "pump".
BUCKET AUGER – Part Number: WR29X43990
BUCKET AUGER
★★★★★
★★★★★
(208)
PartSelect #: PS17626595
Manufacturer #: WR29X43990
The ice bucket auger is located within the ice bucket assembly in your freezer. It stirs and dispenses the ice in the bucket. You may need to replace the auger if your ice maker is noisy, or not dispe...
$63.72
  In Stock
Order within the next 8 hrs and your part ships today!
Temperature Sensor – Part Number: WR55X10025
Temperature Sensor
★★★★★
★★★★★
(66)
PartSelect #: PS304103
Manufacturer #: WR55X10025
This sensor (Temperature Sensor, Thermistor, Refrigerator Temperature Sensor) sends the temperature reading of the compartment to the control board. If you notice your refrigerator is too warm, too co...
$22.80
  In Stock
Order within the next 8 hrs and your part ships today!
Defrost Thermostat – Part Number: WR50X10068
Defrost Thermostat
★★★★★
★★★★★
(18)
PartSelect #: PS1017716
Manufacturer #: WR50X10068
This defrost termination thermostat (Defrost Limiter Thermostat, High Limit Thermostat, Refrigerator Defrost Bi-Metal Thermostat) acts as a safety device to stop the evaporator coil from overheating, ...
$29.24
  In Stock
Order within the next 8 hrs and your part ships today!
Drawer Slide Rail - Right Side – Part Number: WR72X240
Drawer Slide Rail - Right Side
★★★★★
★★★★★
(58)
PartSelect #: PS306944
Manufacturer #: WR72X240
This drawer slide rail is for the right side of your refrigerator. The drawer slide rail attaches horizontally to the refrigerator wall and supports the drawer so it can easily slide in and out. If th...
$28.89
  In Stock
Order within the next 8 hrs and your part ships today!
WATER VALVE WITH GUARD – Part Number: WR57X33326
WATER VALVE WITH GUARD
★★★★★
★★★★★
(80)
PartSelect #: PS16226572
Manufacturer #: WR57X33326
This water inlet valve (Refrigerator Water Inlet Valve Assembly) supplies water to the ice maker and the water dispenser in your refrigerator. It is located at the back of the fridge, beneath the bott...
$88.98
  In Stock
Order within the next 8 hrs and your part ships today!
Refrigerator Ice and Water Filter – Part Number: MWFP
Refrigerator Ice and Water Filter
★★★★★
★★★★★
(76)
PartSelect #: PS8746144
Manufacturer #: MWFP
This OEM ice and water filter fits side-by-side and bottom-freezer GE models. The most common reason you would need to change this part is if you have never updated your model and it is no longer filt...
$68.37
  In Stock
Order within the next 8 hrs and your part ships today!
Drawer Slide Rail - Left Side – Part Number: WR72X239
Drawer Slide Rail - Left Side
★★★★★
★★★★★
(31)
PartSelect #: PS306943
Manufacturer #: WR72X239
This is a manufacturer-approved drawer slide rail for your refrigerator. This slide rail is for the left side of the fridge. All you need to complete this repair is a Phillips screwdriver. Remove the ...
$29.89
  In Stock
Order within the next 8 hrs and your part ships today!
Defrost Heater Harness Kit – Part Number: WR51X10101
Defrost Heater Harness Kit
★★★★★
★★★★★
(15)
PartSelect #: PS1993872
Manufacturer #: WR51X10101
This dual heater kit replaces the single heater. It's redesigned to use two heating elements for a better defrost cycle.
$61.62
  In Stock
Order within the next 8 hrs and your part ships today!
Ice Maker – Part Number: WR30X10093
Ice Maker
★★★★★
★★★★★
(77)
PartSelect #: PS1993870
Manufacturer #: WR30X10093
This 10 by 5 inch ice maker (Electromechanical Icemaker Kit, Ice Maker Assembly) produces ice. This particular model will produce seven crescent shaped cubes every cycle. It is constructed of plastic ...
$216.03
  In Stock
Order within the next 8 hrs and your part ships today!
Dispenser Door Assembly or Flapper – Part Number: WR17X11653
Dispenser Door Assembly or Flapper
★★★★★
★★★★★
(88)
PartSelect #: PS964304
Manufacturer #: WR17X11653
This “Dispenser Door Assembly” (Door Recess Assembly, Ice Door Assembly, Dispenser Door, Refrigerator Dispenser Ice Chute Door Kit, Dispenser Door Flap, Ice Chute Door, Flapper) keeps the room air fro...
$15.57
  In Stock
Order within the next 8 hrs and your part ships today!
Dispenser Door Solenoid Assembly – Part Number: WR62X10055
Dispenser Door Solenoid Assembly
★★★★★
★★★★★
(33)
PartSelect #: PS1483583
Manufacturer #: WR62X10055
This part is a possible option when ice door won't open or shut properly or when water is not dispensing.
$45.89
  In Stock
Order within the next 8 hrs and your part ships today!
Main Electronic Control Board – Part Number: WR55X10942
Main Electronic Control Board
★★★★★
★★★★★
(10)
PartSelect #: PS2364946
Manufacturer #: WR55X10942
This electronic board (Main Control Board Assembly, Control Board, Motherboard) controls the temperature and defrost functions of the unit. This control board is located on the back of the refrigerato...
$397.88
  In Stock
Order within the next 8 hrs and your part ships today!

Questions And Answers for GSS22IFRECC

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the GSS22IFRECC

[Viewing 27 of 27]
Fridge too warm
Fixed by
these parts
Fixing Fixing Fixing
Show All
Freezer section too warm
Fixed by
these parts
Fixing Fixing Fixing
Show All
Leaking
Fixed by
these parts
Fixing Fixing Fixing
Show All
Not dispensing water
Fixed by
these parts
Fixing Fixing
Show All
Ice maker won’t dispense ice
Fixed by
these parts
Fixing Fixing
Show All
Noisy
Fixed by
these parts
Fixing Fixing Fixing
Show All
Ice maker not making ice
Fixed by
these parts
Fixing Fixing
Show All
Freezer not defrosting
Fixed by
these parts
Fixing Fixing Fixing
Show All
Light not working
Fixed by
these parts
Fixing Fixing Fixing
Show All
Will Not Start
Fixed by
these parts
Fixing Fixing Fixing
Show All
Frost buildup
Fixed by
these parts
Fixing Fixing Fixing
Show All
Fridge too cold
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door won’t open or close
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door Sweating
Fixed by
these parts
Fixing Fixing Fixing
Show All
Freezer too cold
Fixed by
these parts
Fixing Fixing Fixing
Show All
Ice maker dispenses too little ice
Fixed by
these parts
Fixing Fixing
Show All
Fridge and Freezer are too warm
Fixed by
these parts
Fixing Fixing Fixing
Show All
Too warm
Fixed by
these parts
Fixing Fixing Fixing
Show All
Fridge runs too long
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door latch failure
Fixed by
these parts
Fixing
Show All
Clicking sound
Fixed by
these parts
Fixing Fixing Fixing
Show All
Ice maker dispenses too much ice
Fixed by
these parts
Fixing Fixing Fixing
Show All
Doesn’t stop running
Fixed by
these parts
Fixing Fixing
Show All
Won’t start
Fixed by
these parts
Fixing Fixing
Show All
Engine revs but auger will not turn
Fixed by
these parts
Show All
Too cold
Fixed by
these parts
Fixing
Show All
Engine runs but cutters do not turn
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Refrigertor water dispenser not working BUT ice machine is working
The very first symptom here is important! The door water dispenser is not working but the ice macine is working. You may only have a frozen water tube in the door so do the following before diagnosing that your solenoid valve is bad: 1) the tube usually runs under the front of the refrigerator and usually has a quick disconnect. Undo the connection and press the dispenser. If water comes out of the tube you have a frozen or blocked tube in the door. 2) Immediately adjust the temperature in the freezer and warm the freezer compartment as much as you can without destroying the freezer contents. Wait 24 hours. This will usually unfreeze the line. Do not waste your time with a hair dryer. NOW, if this doesn't work and you are convinced you need to order and replace the solenoid, follow these steps. Assemble your tools first. I needed a good ratchet set and a screwdriver. A shop towel is helpful for spilled water. A light is handy. Pull out the refreigerator to gain access to the rear of the unit. Unplug the power and close the water valve (older homes, you may need to actually shut the house water supply). Remove the screws which hold the cover over the lower half of the refrigerator. On the left you will see the solenoid. It's always good to see that your new part matches the one you feel needs replaced. They may not match perfectly due to changing design but they should be very similar. One screw holds this part in place and access is very simple. Now simply unplug the electrical connections. In my case, one blue "blade" type connection (powering the water) and one red "blade" type connection powering the ice maker. They are not the same size and this coupled with the coloring means you will not accidently switch them. pull the tubes clear of the solenoid. This is simple and needs no explantion. Grab your new solenoid and reattach both the electrical and water lines (two, remember, ice maker and drink dispencer). Replace the single screw. Re-attach the rear, lower refrigerator cover and go to the front of the unit to check the water. You can listen carefully and hear the power engage from the new part bringing you water. Clean up, replace the refrigerator back to its place and look really tired when your wife sees that you worked "so hard"! You probably saved at least $50-$80 from a service call which can now be used to take the family to dinner after your "exhausting" 15 minute workout of removing about 10 screws and wheeling the unit in and out of place. Writing this article took longer! My 4 year old worked harder holding the flash light!
Parts Used:
WATER VALVE WITH GUARD
  • ralph from bristow, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers, Socket set
1024 of 1138 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic Auger blades broke in ice tray
I used a digital camera and photographed the assembled unit and the metal blades before I started the repair. Then, I removed the top screw on the clear shield. Flip over ice tray and removed two Phillips screws on bottom. Exterior plastic white cover comes off next. The cover sides have hard push-in white plastic tabs. Push them in; pry up top cover with small flathead screwdriver. Slide white top cover up and you will now see the metal blades and assembly. Auger is held in place with a metal c-clip and washer on the end. Use flat head screwdriver to pry off c-clip. Then you will see a nylon round slotted nut. The threads are reverse, use pliers and loosen nut. It is not that tight but pliers are needed. Then it all is loose and ready for removal. I slid all the blades off at one time and kept them stacked together. Slide out auger and clear flat shield cover. Install new auger, clear shield, and metal blade stack. When you put it all back together take a look at the long metal J-hook on the bottom make sure it is in the slot before you make everything tight. Failing to do this will prevent cubed ice from dispensing.
It is not that hard to do the repair it just takes some patience and paying attention to details.
Parts Used:
BUCKET AUGER
  • Tim from Newport News, VA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
583 of 622 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice box and freezer would not get cold,the back wall of the freezer was covered with ice
1. I had to defrost the ice off of the back wall of the freezer with a blowdryer.
2. Removed the four 1/4'' screws and removed the back panel.
3. Defrosted all of the ice off the coils and heater.
4. I replaced the defrost thermostat and heater by following the directions that came with them. The directions are very clear and easy to follow. I had a single element heater, and the replacement was a double element, the directions even explained how to rearrange the wires to make it work. The whole job only really consisted of cutting two wires that are color coded on the thermostat and resplicing the new ones in. I used scotch locks and electrical tape for the splices. The element had connectors on it so I just removed two screws, unplugged two wires and plugged them on the new one.
The greatest thing about this repair was that I troubleshot the problem using the PartSelect website, ordered the parts and they arrived at my house in less than 24 hours.
Thank You.
Parts Used:
Defrost Heater Harness Kit Defrost Thermostat
  • Greg from Aledo, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers
570 of 611 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!