GSL25JFRFBS General Electric Refrigerator - Instructions

Replace main board.

Really easy- turned off ice maker, powered down appliance briefly. Removed ice maker by removing 3 screws with 1/4 nut driver. Unplugged ice maker from power supply. Removed and replaced solenoid arm assembly. Reversed steps and whammy - ice cubes dropped.

After watching the video it was easy. Took less than 10 minutes to replace. PartSelect really does it right with the consumer.

After discovering I could replace the part for a fraction of the cost of having a professional do it, I viewed the short video at part select. I was afraid i was oing to cause further damage when I was forcing the disassembly. The video confirmed I was doing it properly.

I looked at the video that came with the part and followed what i saw. My wife and i was about to go out and spend between $1500 and $2500 on a new refrigerator due to continuous defrosting. It had been happening for about a year. I followed the instructions from the video and the defrosting has stopped. Thanks so much for the video and the part! We do not need a new refrigerator after all.

Took old part out , put new part in. Was so easy thought we did it wrong. Ice maker working great, have lots of ice now. Thank you. Colleen

Removed water filter and inserted plug (works great and water flow increased)

I wish I could say differenet but it was very easy just a bit of pressure on on side an the dairy door snap in place.Thank you for following up

Removed the dispenser panel and replaced-less than 10 min and a savings of $300.00 for a service call.

Removed Flat Panel from front and used screwdrivers to remove screws and access spring and flapper, one note, once i did have access to this section i was able to see that the main reason the flapper was not closing was because the Dispenser Door Solenoid Assembly was frozen solid and needed to be replaced, I had not ordered this part and therefore had to order it at a later time, and repeat the repair, best to open this section up find all the damaged parts and then order...

took out shelves and removed the back plate my removing 2 screws with a nutdriver.removed the old defrost timer and defrost heater which was really easy.then installed the new ones.the video i watched on the website was really helpfull.

Used a nutdriver, I could put it on both heads and remove and replace. So easy a child could do it. Less than two minutes.

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

as per video

First, I replaced my water filter but when it didn't work I googled the problem and the most advice I found was the double outlet water valve must be bad. SO I ordered the parts thru parts select. But when I installed the valve, the water dispenser still didn't working. I went back to parts select website and to see if somebody had the same problem. A gentlemen posted that if the water line is frozen, no water will come out. So I defrosted my refrigerator and turned it on again and it finally work. So now, I wasn't sure if the REAL problem I had was just frozen line or a bad valve. I decided to keep the water valve since my ref was almost 10yrs old. (But I still don't know why my water line froze.)