GHW9100LW1 Whirlpool Washer - Instructions

most would have thrown out the appliance ,but at $1000.00 to replace it was worth the shot to repair ,basket was under warranty (450.00 value )part damaged was the outer plastic being damaged ,washer repaired for under 150.00 and back inservice saved 850.00

Took old one off and put the new one on. Was very easy. Hardest part was disconnecting hose clamps, which was still easy

It was easy-unscrewed (use a torx screw driver-star) the 2 screws & put the handle in place & put the screws back in.

took front panel off. Pump is right there easy to work on. Used pliers to take 2 hose clamps off. Used star screw driver to take 2 screws off of pump and removed old pump. The Assemblely goes the same way but the drain hose coming off the tube is not very easy to get back on. Hose is flimsey and the stem, on the end of the drain pump isnt long enough to keep hose on while tring to slide hose clamp back on.

Read the instructions provided by PartSelect.....and with a bit of patience I installed all four bolts so the washer's inside agitator was not damaged in shipping. I highly recommend that anyone who is moving/storing or shipping their washer that you find the correct shipping bolts according to your model and make and install them prior to moving your appliance.

Simple reair .....Two Torx screws to remove on inside of handle also remove the rubber finger cushion from the old handle so you can install it on the new unit, this is not included. The whole repair souldnt take more than 5 - 10 minutes.

Took out screws and replaced it with the new handle.

Removed top cover. Manually opened door through top cover opening. Removed 3 screws at front holding assembly. Removed 3 harnesses attached to assembly. Replaced with new assembly and screwed back in. Replaced harnesses. Certainly an easy DIY job.

It was easier than I thought it would be: 1. Order the parts 2. Upon arrival, went back to the website to get an idea as to how to install the parts. 3. Although a little apprehensive at first, the replacement and installation of the parts went flawless and was doing the laundry 15 min. Later. Done!

replaced in less than 5 minutes

I did not replace the pump body. I just removed the motor with the 3 screws. Put the new one on. This way I did not need to mess with the hose clamps.

Pulled washer away from wall, unplugged power from outlet, shut off water valves and removed hosed from back of machine. Removed the 3 screws on the back top of washer that holds top on and removed top. Unplugged the 4 wires on the back of the valve, removed the screw that holds the valve in place, pulled the valve out so I could remove the hose clamp and hose from the valve. I then reversed the operation. It is really pretty simple.

I looked up the repair on YouTube. The exact repair was there. Remove the ring around the boot. Remove the part of the boot by the latch. Remove the latch. Replace the latch . Refit the boot. Replace the wire ring making sure the spring is down. Taadaa! The guy on the video took two minutes or so. It took me seven because I was very deliberate in my work, and it was the first time I had done this repair. The wife was very pleased!

My son pulled the washer out and found the parts that was leaking. He ordered the parts from your company. they arrived the next day and he re-pared the leaks and all is well.thank you

The product came on time and was perfectly rapped , it took me 15 mins to install after watching you tube videos on front loader washer . I was happy I didn't have to call a service man in . . . .