Models > GH6177XPQ3 > Instructions

GH6177XPQ3 Whirlpool Microwave - Instructions

All Instructions for the GH6177XPQ3
61 - 75 of 152
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
glass turn table cracked needed a new one
easy to replace, just the same as cleaning the turntable and placing back in the micorwave;
Parts Used:
Glass Cooking Tray
  • sharon from LAS VEGAS, NV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Grill Broke
SO EASY... It just clipped right in...
Parts Used:
Stainless Steel Vent Grill and Clips
  • Andrew from Carlsbad, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
my pan that browns the meat started to bubble and peal
I really did not have a repair on the microwave just a replacement of the browning pan
Parts Used:
PAN-CRISP
  • Lillian from SAN JOSE, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The original clips were broken on the vent
New vent came and fit perfectly.
Parts Used:
Stainless Steel Vent Grill and Clips
  • Susan from LAFAYETTE, LA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken vent gripll
removed old one. new one snapped right in
Parts Used:
Stainless Steel Vent Grill and Clips
  • BILL from SAINT JOHNS, FL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Turntable did not work
Ordered a new motor. Removed the outside trim of the oven-microwave combo. 2 screws at the bottom of the trim. Removed the screws that held the combination micro and oven unit in place. Removed the top and bottom black plastic grill of the microwave. 3 screws each. Pulled the entire unit out about 1 inch exposing the screws at each side of the microwave that hold it in place.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.
Parts Used:
MOTOR-TURN
  • Eldon from ORANGE, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Very unusual. we had a brief fire inside the microwave which destroyed all the moving rotary parts.
First, we had to clean up all the interior surfaces, which was just cleaning. There was no internal damage. Then, just setting the center connector, rotary rollers and glass plate. Simple
Parts Used:
RING-TURN Drive Coupling Glass Cooking Tray
  • Jan from ELK GROVE, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Over range microwave vent grille fell off. No clips attached.
Ordered new grille in hopes it would have clips attached as none were on old grille. Kept my fingers crossed that new grille would just snap back on. It did. No tools required.
Parts Used:
Vent Grille - Black
  • Linda from FT LAUDERDALE, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drive coupling cracked would no longer rotate turntable plate
used screw driver to pry up old part. lifted right off. line up drive couple drive push on. repair took less than 1 minute to repair. works like new
Very Pleased with Parts Select replacement parts
Parts Used:
Drive Coupling
  • Edward from CENTENNIAL, CO
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Vent grille broke
Fit it into the frame and it popped right in.
Parts Used:
Vent Grille - Black
  • Sharyn N from CLEMMONS, NC
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken vent for microwave.
Exact piece arriven. All I had to do was line it up on the correct bottom guides press hard on the top and it snapped into place. Everything lined up.
Parts Used:
Vent Grille - White
  • Andrew from JACKSONVILLE, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
One of the wheels came off
Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul
Parts Used:
RING-TURN
  • Paul from EXETER, NH
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
vent grille was damaged and would not stay on.
easy squeasy, lemon-peasy. Took all of 15 seconds. Opening the box took longer than installing the vent. It just snaps right in place.
Parts Used:
Stainless Steel Vent Grill and Clips
  • Beau from Cary, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The old coupling melted and the tray cracked in half.
It took me 15 minutes total - 5 minutes to clean the microwave, 1 minute to install three new parts, and 9 minutes to enjoy my celebratory glass of wine!
Parts Used:
Drive Coupling RING-TURN Glass Cooking Tray
  • Diane from Sheridan, AR
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic holders for mounting clips broke off
snapped new grill in place
Parts Used:
Vent Grille - Black
  • Geoff from Rockwall, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GH6177XPQ3
61 - 75 of 152
Back to Top