GH4184XSB0 Whirlpool Microwave - Instructions

Received new cover the next day. Snapped new cover in place with no problems.

Snap the new one in place.

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

Problem was easily diagnosed using the internet as a resource, problem was a bad stirrer motor. Hardest part of the repair was the removal of the microwave. Once off the wall, you remove the outer cover and a molded plastic casing directly underneath the outer cover at the top of hte microwave to expose the stirrer motor. Removed two screws and two wires and the old motor is out. Did exactly the opposite to install the new motor. The kit I recvd included among other things the motor, a new inside cover, plastic rivets and even silicone to seal the inside cover. I am sure I saved a couple hundred dollars by doing myself.

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

I removed the front cover, which allowed access to the soap dispenser. You need a 1/4" driver set to unscrew the dispenser. I installed the new dispenser, and the dishwasher worked great. The inital problem of the soap door not opening, and the rinse aid not dispensing, was solved.

Removed the glass cover and replaced the bulb. Very simple.

Easy order for new replacement grill. Easy to pop it right back on.

replaced burnt parts

Attached additional 3rd clip using phillips screwdriver, snapped vent into place. That's it. Addionally, I ordered the piece (at roughly one third price of factory) on thursday, it arrived saturday !! Excellent !!

Remove broken grille and snapped new grille in place. Very easy to do. Very poor design by Whirlpool. This is my third grille in 4 years. Thank you PartSelect for carrying the replacement grilles.

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

just snap in to the place very easy

Opened the box, took the new part out and snapped it on. Easy. Fit perfectly. Took less than 2 minutes. Looks great!

The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier