GFC800-02 General Electric Food Waste Disposer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Splash guard worn out
pulled out the old and stuck in the new--so easy a caveman could do it.
Parts Used:
-
Aubrey from Hugo, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
5 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No stoppet
-
Alan from HOPEWELL, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old one wore out and had shrunk and coming loose.
Turn off power to unit (switch off) Put rubber gloves on and pulled out old guard. Then cleaned the area on the sides and the under the lip with wet paper towels. Crud had built up. Once clean push the new guard in. Since it was new it was tight .push down moving finger pressure around until it seated. Works fine.
Parts Used:
-
Tom from ORLANDO, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old splash gard became loose, felt always into grinder
just wet the surface of the new part and pushed it with some force into its place. It was real easy
Parts Used:
-
robert from coral gables, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Could not find a stopper for the disposal. You supplied the proper one.
Pushed the stopper down into the disposal until it stopped. Works like a champ. Thank you. You are a great resource for parts I may need in the future.
Parts Used:
-
Sidnee from Topeka, KS
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!