FGMV174KFA Frigidaire Microwave - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Instructions did not match the assembly of the ice maker.
I managed to move the auger far enough to allow me to insert the cup-drive and then realign the auger with the new cup-drive. I also have had one to break very shortly after installing it. This is my second part to replace and this one went really smooth, since I understood that the initial parts installation instructions did not apply on my ice maker.
Parts Used:
-
Harry from Cypress, TX
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Power, light, and clock work, micro/turntable not working
Much like the other post: 1. Removw vent case on top (3 screws) 2. Remove cover with control buttons (1 screw). 3. Removed bottom relay switch and replaced. Tight working space so be patient. Took 15 minutes Needle nose pliers used to crimp connector onto switch
Parts Used:
-
adam from new orleans, LA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cover was damaged
-
Genevieve from Lacey, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Microwave would not heat
Determining the root cause was fairly simple - but one should always identify the basic repair part first that may be the root cause - in this order - Diode - HV Capacitor - Magnetron due to costs of fixing the issue. I found that after replacing the two major components it may have been just the Diod/Rectifier a low coat resolution - but one never knows if the issue was one or many problems that wouldn't allow the Microwave to heat. The team at PartSelect was very helpful and was able to expidite the Magnetron to my residence to start the repair process KUDO's to the Customer Service Team!
Parts Used:
-
David from Findlay, OH
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
annual replacement of filter
My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks
Parts Used:
-
Carol from Framingham, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!